Abstract:A novel theoretical model capable of quantifying the stress causing transient thermal strain (TTS) in heated concrete has been proposed in this work. It can be used in finite element models or as a direct design equation to help structural designers in assessing the stress developed during heating of concrete members caused by combined actions of mechanical loads, heating fluxes and end restraints. The model classifies heated concrete problems into three categories; concrete members heated to a certain temperature then loaded; concrete members stressed to a certain level and then heated to a certain temperature under load; concrete members heated with fully restrained ends with or without external loading. The new TTS equation has been incorporated in a novel coupled thermo-mechanical finite element model in the framework of ABAQUS. Material models capable of capturing the constitutive behaviour and specifically the degradation of material properties experienced by concrete exposed to elevated temperatures, have been selected from the literature and have been adapted to include TTS and, where absent, temperature dependence. The FE model, along with the developed stress equation, has been validated against experimental results in which samples were tested under various loading configurations and boundary conditions. It has been shown to successfully reproduce the results for all of the studied cases. Furthermore, in exploring these scenarios a number of observations were made. Firstly, it was found that the stress developed under restraint is lower than under applied preload, but that stress relaxation in part due to TTS is higher in preloaded samples. Secondly, the limit of elastic behaviour appears to be reduced in samples subject to free thermal expansion compared to those under restraint. Finally, while free thermal expansion is critical to the overall stress-strain response there is evidence that it varies with the applied stress and significantly increases at high temperatures.

Temperature-stress coupling constitutive relationship of concrete

Concrete Constitutive Relationships Under Different Stress-Temperature Paths

Experimental study on dynamic behavior of concrete at elevated temperatures

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

Stress–strain constitutive equations of concrete material at elevated temperatures

Study on the Constitutive Relationship between Ordinary Concrete and Nano-Titanium Dioxide-Modified Concrete at High Temperature

A Generalised Model for Direct Prediction of Stresses in Concrete at High Temperatures

Temperature-Dependent Coefficient of Thermal Expansion of Concrete in Freezing Process

Effect of Elevated Temperatures on Compressive Strength of Concrete

FREE THERMAL EXPANSION STRAIN OF CONCRETE WITH DIFFERENT STRENGTH GRADES EXPOSED TO DIFFERENT RAISING TEMPERATURE RATES

Relationship Between Characteristic Tensile Strain and Curing Age of Concrete

Experimental Investigation of the Static Expansion Tensile Behavior of Concrete after Exposure to Elevated Temperatures

Effect of Reinforcement on Early-Age Concrete Temperature Stress: Preliminary Experimental Investigation and Analytical Simulation

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

Strain-Rate Sensitivity of Concrete: Influence of Temperature

Dynamic Tensile Properties and Energy Dissipation of High-Strength Concrete after Exposure to Elevated Temperatures

SHORT-TERM THERMAL CREEP MODEL OF CONCRETE BASED ON EXPERIMENTS

Stress Prediction in Very Early-Age Concrete Subject to Restraint under Varying Temperature Histories

Effect of Thermal Parameters on Hydration Heat Temperature and Thermal Stress of Mass Concrete

Experimental Study of Thermal-Hydraulic-Mechanical Coupling Behavior of High-Performance Concrete

Experimental Study on Early-Age Crack of Mass Concrete under the Controlled Temperature History