Abstract:This article introduces a liquid desiccant fresh air processor. Its driving force is low-grade heat (heat obtained from 65 – 75°C hot water). Inside the processor, the air is dehumidified by the evaporative cooling energy of the indoor exhaust air. A four-stage structure is used to increase the efficiency of the combined sensible and latent heat recovery from the exhaust air. A mathematical model of the fresh air processor was set up using Simulink®. A liquid desiccant fresh air processor was constructed and tested for outside air conditions of 29.1 – 33.6°C, 13.7 – 16.7g/kg humidity ratio, and supply air conditions of 23.6 – 24.2°C, 7.4 – 8.6g/kg humidity ratio. The average measured COP f was 1.6 (cold production divided by latent heat removed) for the range of conditions tested. The corresponding average COP sys of the system including the regenerator was 1.3 (cold production divided by heat input). The detailed operating parameters of each part of the test unit were also measured. The test data was compared with the simulated performance. The characteristic coefficients (such as the volumetric mass transfer coefficient of the air-water evaporative cooling module, etc.) in the mathematical model were modified to calibrate the model output to the measured data. The calibrated simulation model was used to investigate the control strategy of the fresh air processor. The flow rate of the strong solution into the unit and the number of operation stages may be controlled separately or together to meet different indoor air requirements at different outdoor conditions. The hot water driven liquid desiccant air conditioning system was compared with a typical vapor compression system with an average COP of 4.5; the pump and fan power of the proposed system was 40% of the combined chiller, pump, and fan consumption. We achieved savings of over 30% of the power consumption compared with the traditional system under the designed outdoor air conditions.

Analysis of open-cycle solid desiccant air conditioning system and its key component-dehumidifier

Analysis of a Hybrid System of Adiabatic Absorption two-stage Liquid Desiccant and CO2 Transcritical Cycles

Analysis of a Hybrid System of Liquid Desiccant and CO2 Transcritical Cycles

MATHEMATICAL MODEL AND PERFORMANCE ANALYSIS FOR LIQUID DESICCANT COOLING SYSTEM

Study on a Novel Hybrid Desiccant Dehumidification and Air Conditioning System

Model-based Investigation of a Heat Pump Driven, Internally Cooled Liquid Desiccant Dehumidification System

Analysis on Integrated Low Grade Condensation Heat Powered Desiccant Coated Vapor Compression System

Numerical Research On A New Type Of Refrigerant Cooling Solid Desiccant Dehumidification Device

Analysis on a Hybrid Desiccant Air-Conditioning System

Parametric analysis of novel two-stage desiccant cooling system

Analysis on Desiccant Coated Heat Exchangers Based on a New Performance Parameter and Thermodynamic Model

Performance Analysis on the Internally Cooled Dehumidifier Using Liquid Desiccant

Performance Optimization Analysis of the Composite Liquid Desiccant Evaporative Cooling Air-Conditioning System

Simulation and Experimental Analysis of A Fresh Air-Handling Unit with Liquid Desiccant Sensible and Latent Heat Recovery

Study on the Performance of Dehumidifier in the Liquid Desiccant Air Conditioning System

Comparison of Internally Cooled and Adiabatic Liquid Desiccant Dehumidification-Regeneration System

A Novel Semi-Coupled Solid Desiccant Heat Pump System - Part 1: Simulation Study

Research Progress in Liquid Desiccant Air-Conditioning Devices and Systems

Heat and Mass Transfer Analysis and Performance Comparison for Different Solid Dehumidification Methods

THE SIMULATION COMPARISON AMONG THREE DESICCANT WHEEL COOLING SYSTEMS

Experimental Study on a Hybrid Desiccant Dehumidification and Air Conditioning System