Abstract:With the increasing of global energy requirements and environmental problems, the use of solar thermal energy has attracted widespread attention. The selective solar absorption coating is the most important part of a solar thermal conversion device. At present, most of the coatings work well in a vacuum at a high temperature, while not stably in the air environment. Based on the high-temperature resistant and infrared-reflective properties of ITO, a multilayer film of SiO2/Si3N4/SiO2/ITO/Cr has been designed as a selective solar absorber. The genetic algorithm is applied to optimize the material and thickness selection for each layer. The results show that the optimized multilayer film could achieve a high solar absorptance up to 90% while keeping a relatively low infrared emittance around 50% for temperature change between 600°C and 900°C. All the materials composing this film have been tested before to be chemically stable at a high temperature up to 900°C in the air environment. It is also adaptive to different incident angles from 0° to 60°. The finite-difference time-domain method was also adopted to plot the energy density distribution for different wavelengths, which provided the underlying mechanism for the selective emission spectrum. The findings in this study would provide valuable guidance to design a low-cost selective solar absorption coating without the need for vacuum generation.

Design on solar selective absorbing surface with interference effect

Omnidirectional, Thin Metasurface Exhibiting Selective Absorption for Un-Polarized Broadband Incidence

Sputtered solar selective absorbing surfaces based on aluminum and stainless steel composites

Solar spectral selective absorbing surface by interference and absorption

SOLAR SELECTIVE ABSORBER BASED ON PARTICLE-SCATTERING EFFECT

Scalable All-Ceramic Nanofilms As Highly Efficient and Thermally Stable Selective Solar Absorbers

Optimization and Preparation of the High-Efficiency Solar Selective Absorber Based on Double W-SiO2 Cermet Layers

A Novel Design For High-Temperature Solar Selective Coating

Effect of Metal Particles in Cermets on Spectral Selectivity

Theoretical Design of a Multilayer Based Spectrally Selective Solar Absorber Applied under Ambient Conditions

Tunable Composite Absorber with Active Frequency Selective Surface

High Performance Mid-Temperature Selective Absorber Based On Titanium Oxides Cermet Deposited By Direct Current Reactive Sputtering Of A Single Titanium Target

A review of cermet-based spectrally selective solar absorbers

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Study on A Novel Selective Solar Absorber with Surface Ultrathin Metal Film

Sputtered Aluminium Composite Selective Absorbing Surfaces

Optimize the dielectric slab of the tunable active frequency selective surface absorbing material

Design of Multilayer Planar Film Structures for Near-Perfect Absorption in the Visible to Near-Infrared.

A Checkerboard Selective Absorber With Excellent Spectral Selectivity

Design of a Multilayered Frequency Selective Surface Absorber for the Suppression of Grating Lobes

Accurate Design of Solar Selective Absorber Based on Measured Optical Constants of Nano-thin Cr Film