Abstract:At frequencies below 2 GHz, conventional microwave absorbers are limited in application by their thickness or narrow absorption bandwidth. In this paper, we propose and fabricate an ultra-thin broadband active frequency selective surface (AFSS) absorber with a stretching transformation (ST) pattern for use in the ultrahigh-frequency (UHF) band. This absorber is loaded with resistors and varactors to produce its tunability. To expand the tunable bandwidth, we applied the ST with various coefficients x and y to the unit cell pattern. With ST coefficients of x = y = 1, the tunability and strong absorption are concisely demonstrated, based on a discussion of impedance matching. On analyzing the patterns with various ST coefficients, we found that a small x/y effectively expands the tunable bandwidth. After this analysis, we fabricated an AFSS absorber with ST coefficients of x = 0.7 and y = 1. Its measured reflectivity covered a broad band of 0.7-1.9GHz below -10 dB at bias voltages of 10-48V. The total thickness of this absorber, 7.8mm, was only similar to lambda/54 of the lower limit frequency, similar to lambda/29 of the center frequency, and similar to lambda/20 of the higher limit frequency. Our measurements and simulated results indicate that this AFSS absorber can be thin and achieve a broad bandwidth simultaneously. (C) 2015 AIP Publishing LLC.

Composite Absorber of Broadband and High Attenuation with Spiral Frequency Selective Surfaces

A Composite Absorber of FSS and Area-coated Honeycomb Using High-loss Materials for Broadband Applications

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Ultrabroadband and Omnidirectional Absorbers Based on a Tandem Multilayer Structure

Tunable Composite Absorber with Active Frequency Selective Surface

Thin and Broadband Electromagnetic Absorber Design Using Resistors and Capacitors Loaded Frequency Selective Surface

Flexible Design and Realization of Wideband Microwave Absorber with Double-Layered Resistor Loaded FSS

An Ultra-Thin Broadband Active Frequency Selective Surface Absorber For Ultrahigh-Frequency Applications

An Ultra-Wideband Metamaterial Absorber With Active Frequency Selective Surface

Ultrabroadband Double-Sided and Dual-Tuned Active Absorber for UHF Band

Broad bandwidth of thin composite radar absorbing structures embedded with frequency selective surfaces

A Broadband Metamaterial Absorber Design Using Characteristic Modes Analysis

Design of a Multilayered Frequency Selective Surface Absorber for the Suppression of Grating Lobes

Ultra-wideband Passive Double-Layer Absorber Design from the Reflective Point

Broadband and Omnidirectionally Matched Absorber for a Discrete Source

Design and fabrication of a wideband frequency selective surface absorber loaded with a high dielectric thin layer

Anisotropic Absorbing Honeycomb and FSS Composite Structure for Curved Broadband RCS Reduction

Frequency selective surface composites with honeycomb absorbing structure for broadband applications

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

A Novel Tunable Frequency Selective Surface Absorber with Dual-Dof for Broadband Applications.

Optimize the dielectric slab of the tunable active frequency selective surface absorbing material