Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

Anisotropic Absorbing Honeycomb and FSS Composite Structure for Curved Broadband RCS Reduction

Surface Impedance Modulation of FSS Composite Absorber for RCS Reduction at Normal and Grazing Incidence

A Composite Absorber of FSS and Area-coated Honeycomb Using High-loss Materials for Broadband Applications

Tapered Resistive Sheets and FSS Absorber Loading for the Wideband RCS Reduction of the Elliptic Surface at TM Polarization

Broad bandwidth of thin composite radar absorbing structures embedded with frequency selective surfaces

Tapered Resistive Sheets Loading to the FSS Absorber for the Wide-Angle Monostatic RCS Reduction Applications

Frequency selective surface composites with honeycomb absorbing structure for broadband applications

Design of a Dual-Band Electromagnetic Absorber with Frequency Selective Surfaces

Broadband Flexible Metasurface-Inspired Antenna Array with Lower Scattering on Curved Surfaces

Composite Absorber of Broadband and High Attenuation with Spiral Frequency Selective Surfaces

A Broadband Tunable Frequency Selective Surface Absorber For Oblique Incidence Applications

A Wideband Transmission Frequency Selective Surface Rasorber

Partition Layout Loading of Frequency Selective Surface Absorbers on the Curved Surfaces for the Significant RCS Reduction

Multisection Step-Impedance Modeling and Analysis of Broadband Microwave Honeycomb Absorbing Structures

A Frequency-Selective Surface Rasorber Based on Four Functional Layers

Ultrabroadband Double-Sided and Dual-Tuned Active Absorber for UHF Band

Multistate Active Control RCS Signature for the Continuous Adjustment Absorber/reflector Transformation Applications.

Broadband Frequency Selective Surface Absorber With Dual-Section Step-Impedance Matching for Oblique Incidence Applications

Ultra-wideband RCS reduction based on reflection cancellation and tunable absorption

Dual-broadband flexible metasurface based on the staggered triangular checkerboard layout for RCS reduction

Broadband RCS Reduction Using Circular Sector Structure