Effects of Ti addition on the soft magnetic properties of Fe-N films

Heying Wang,Enyong Jiang,Haili Bai,Ping Wu,Y�� W��ng,Fengfei Gong
DOI: https://doi.org/10.1088/0953-8984/9/40/011
1997-01-01
Abstract:FeTiN films with good soft magnetic properties were prepared on Si and NaCl single-crystal substrates-by facing-targets sputtering (FTS). The effects of Ti addition on the structural and magnetic properties of Fe-N films were investigated. Ti has been found effective in improving the soft magnetic properties as well as the thermal stability of FeN films. For the films containing 5-12 at.% Ti prepared under sputtering conditions of pN(2) = 0.04-0.07 Pa, a substrate temperature of 100 degrees C, and a sputtering rate of 0.2 nm s(-1), the following properties are observed: very high saturation magnetization 4 pi M-s (2.3-2.5 T), low coercivity H-c (160-240 A m(-1)), and high relative permeability mu (3000-3500 at 1 MHz). The thermal stability of these films was also found to be good, e.g. H-c was less than 240 A m(-1) and 4 pi M-s was higher than 2.3 T for the films annealed up to 500 degrees C. The crystal structures of the FeTiN films were examined with an x-ray diffractometer and a transmission electron microscope. Ti addition affects the formation of magnetic iron nitride phases and makes the crystallites small. The fine-grained Fe-N phase, together with finely dispersed TiN precipitates, is considered to be one of the main factors responsible for the good magnetic properties and thermal stability.
What problem does this paper attempt to address?