Abstract:The present work focuses on the combination of ceria with another oxide of different ionic valences from period 3 (Mg(2+), Al(3+), and Si(4+)) using coprecipitation method, followed by calcination at 450 and 750°C, respectively. The textural, structural, morphological and redox properties of nanosized ceria-magnesia, ceria-alumina and ceria-silica mixed oxides have been investigated by means of N(2) physisorption, XRD, Raman, HRTEM, DRS, FT-IR, and H(2)-TPR technologies. XRD results of these mixed oxides reveal that only nanocrystalline ceria (ca. 3-6nm for the 450°C calcined samples) could be observed. The grain size of ceria increases with the increasing calcination temperature from 450 to 750°C due to sintering effect. The highest specific surface area is obtained at CeO(2)-Al(2)O(3) mixed oxides when calcination temperature reaches 750°C. Raman spectra display the cubic fluorite structure of ceria and the existence of oxygen vacancies, and displacement of oxygen ions from their normal lattice positions in the ceria-based mixed oxides. DRS measurements confirm that the smaller the grain size of the ceria, the higher indirect band gap energy. H(2)-TPR results suggest that the reductions of surface and bulk oxygen of ceria were predominant at low and high calcination temperature, respectively. Finally, CO oxidation were performed over these ceria-based mixed oxides, and the combination of CeO(2)-Al(2)O(3) exhibited highest activity irrespective of calcination temperature, which may due to excellent textural/structural properties, good homogeneity, and redox abilities.

Preparation of Ce-Mo complex oxide ultrafine particle catalyst by sol-gel method

Preparation of La-Mo Series Complex Oxide Ultrafine Particle Catalysts by Sol-gel Method

Preparation of Fe-2(Moo4)(3) Ultrafine Particle Catalyst

Preparation and Characterization of Ultrafine Rare Earth Molybdenum Complex Oxide Particles

Study of preparation of cobalt cerium complex oxides catalyst by sol-gel method

Structure and reactivity of ultrafine Ce–Mo oxide particles

Study on the preparation and the properties of cobalt cerium mixed oxides catalysts with ultrafine particals

Preparation Of Bi2o3 Center Dot 3moo(3) Oxide Catalyst By Sol-Gel Method And Its Microcalorimetric Studies Of Surface Acidity And Basicity

Study on synthesis and modification of Ti/Ce composite oxide

Preparation and characterization of CeO2 with different particle sizes and morphology

Structure and reactivity of ultrafine Fe-Mo oxide particles prepared by the sol-gel method

Study on the Reactivity of Ultrafine Cerium–molybdenum Oxide Particles in the Absence of Molecular Oxygen

Controlled synthesis of Ce0.8Y0.2O1.9 nanoparticles by reverse microemulsion

Preparation and Characterization of CeO<sub>2</sub> with Different Particle Sizes and Morphology

Preparation of Super-Stable MCNTs/CeO_2 Nanocomposites

Preparation of Ultrafine Ce-Zr-Ba Mixed Oxide Powder with High Surface Area

Synthesis of Cerium(IV) Oxide Ultrafine Particles by Solid‐State Reactions

Preparation And Reduction Behavior Of Mo-Cu Powders By Sol-Gel

Preparation of Nanocrystalline Mullite Contained Microspheres by Sol-gel Process in Oil-in-Water Emulsion

Textural, Structural, and Morphological Characterizations and Catalytic Activity of Nanosized CeO2–MOx (M = Mg2+, Al3+, Si4+) Mixed Oxides for CO Oxidation

Shape-controlled synthesis of CeOHCO3 and CeO2 microstructures