Abstract:High Mn twinning-induced plasticity (TWIP) steels have been the focus of research in the past decade due to their superior combination of strength and ductility. In-situ TEM mechanical testing is an efficient tool to provide direct insights into fundamental deformation mechanisms of materials, and thus, key observations by in-situ TEM mechanical testing are required to unravel the deformation mechanisms of TWIP steels. The present work reports three deformation mechanisms of TWIP steels observed by in-situ TEM mechanical testing: (1) Formation of deformation twins from grain boundaries, (2) Interference of growth of a deformation twin by a stacking fault, and (3) motion of extended dislocations contributing to the plasticity. Firstly, the formation of deformation twins by direct emission of Shockley partial dislocations from grain boundary sources was observed. The different degree of the motion of twinning partial dislocations indicates a different degree of growth kinetics of deformation twins depending upon local stress states. Secondly, the motion of Shockley partial dislocations in an inclined twin confined between a precipitate and a stacking fault was observed, thereby leading to the growth of the deformation twin. The sluggish motion of Shockley partial dislocations near the stacking fault indicates a strengthening effect of stacking faults. Thirdly, direct evidence of motion of extended dislocation across the entire grain was obtained, which suggests a contribution of extended dislocation slip on the plasticity of TWIP steels.

Dynamic Observations on Tem In-Situ Tensile Deformation of Mn8 Steel

In Situ Nanomechanical Testing of Twinned Metals in a Transmission Electron Microscope

In Situ Tem Nanomechanics

In Situ TEM Observation on Martensitic Transformation During Tensile Deformation of SUS304 Metastable Austenitic Stainless Steel

Transmission electron microscopy observation of a deformation twin in TWIP steel by an ex situ tensile test

Deformation Behavior and Microstructure of Low Carbon High Manganese Steels in Tensile Strain

In-situ TEM investigation on deformation mechanisms of a fine-grained 316L stainless steel

The Crystallographic Mechanism for Deformation Induced Martensitic Transformation Observed by High Resolution Transmission Electron Microscope

Microstructure Evolution and Deformation Mechanism Change in 0.98c–8.3mn–0.04n Steel During Compressive Deformation

In-situ neutron diffraction investigation of two-stage martensitic transformation in a 13%Mn steel with serrated deformation

In Situ Observation of Tensile Experiments on Austenitic Stainless Steel by Espi

In Situ Scanning Electron Microscopy Observation of Deformation and Fracture Behavior of Ti-3zr-2sn-3mo-25nb Alloy

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

In-situ TEM investigation of deformation mechanisms of twinning-induced plasticity steel

Microscopic mechanism of work hardening of austenitic medium manganese steel

Tensile Deformation Behavior of High Strength Anti-Seismic Steel with Multi-Phase Microstructure

In-situ Quantitative TEM Investigation on the Dynamic Evolution of Individual Twin Boundary in Magnesium under Cyclic Loading

Microstructural Evolution of Martensite During Deformation in Zr50Cu50 Shape Memory Alloy

In situ observation of dislocations at crack tip insingle crystalline tantalum

Investigation of Active Slip Modes Via In-Grain Misorientation Axis and Strain Compatibility of Ta2 Alloy During In-Situ Tensile Deformation

B11-O-10In Situ Atomic Scale Mechanical Microscopy