Abstract:The phase transformations in an as-cast Fe-30Mn-8.8Al-0.3Si-0.15C steel were analyzed experimentally and numerically with a Calphad-based method during heat treatment. The nonequilibrium phases were determined using the Thermo-Calc Scheil module and the equilibrium phases with Themo-Calc based on the steel chemical composition. The precipitated phases were analyzed with TC-PRISMA using the chemical composition, nucleation site, and temperature among other factors. An ingot of this chemical composition was vacuum-melted using pure elements under an Ar gas atmosphere. As-cast steel specimens were annealed and solution-treated, quenched, and then aged at different temperatures. Heat-treated specimens were analyzed by different techniques. The results indicated that the microconstituents are the α and γ phases for the as-cast, homogenized, and quenched conditions. The main difference among these conditions is the distribution and size of the γ phase, which produced a change in hardness from 209 to 259 VHN. In contrast, the aging treatment at 750 °C caused a decrease in hardness from 492 to 306 VHN, which is attributable to the increase in volume fraction of the γ phase. On the other hand, the aging treatment at 550 °C promoted precipitation hardening from 259 to 649 VHN because of the κ precipitate formation. The calculated results for the different heat treatments with the Calphad-based method agreed well with the experimental ones. In addition, the intragranular precipitation of the κ phase could be simulated using the nucleation and growth and coarsening mechanisms based on a Calphad method.

Phase Transformation Of Fec2o4 Center Dot 2h(2)O Heat Treated In H-2/Nh3

Phase transformation of FeC2O4 · 2H2O heat treated in H2NH3

Mssbauer Effect in Ultrafine Particles with Fe-C Solid Solution, γ-Fe and Fe_3C Phases

Phase Transitions and Deoxidizing Effect in the Thermal Decomposition of Hydrous Ferrous Oxalate

Study on Precipitation in (cocrfemnni)90al6ti4 High Entropy Alloy

Structure And Magnetic Properties Of Co2.73fe0.27o4 Synthesized By The Heat-Decomposition Method

Phase Transition During Sintering Process Before Nucleation of TFA-MOD YBa2Cu3O7-δ Films

X-ray Diffraction and Mössbauer Studies of Phase Transformation in Manganese Ferrite Prepared by Combustion Synthesis Method

Phase Transition During Heat Treatment of Precursor Before YBa 2 Cu 3 O 7− Δ Nucleation in TFA–MOD Method

Effect of Fe on phase transformation of low temperature Cu-Al-Mn memory alloy

Differential Scanning Calorimetry and Mössbauer Effect Studies of the Thermal Decomposition of Hydrous Ferrous Oxalate in Hydrogen

Phase Transition Behavior in Fe2O3 Nanofibers

Phase transformation and strengthening of the gas-atomized FeCoCrNiMo0.5Al1.3 high-entropy alloy powder during annealing

Evolution of the phase structure after different heat treatments in NiCoFeCrGa high entropy alloy

Phase Transformations in Reduced-Activation Duplex Alloy Fe52Mn30Cr18 under Isothermal Heat Treatment

Phase Transformation and Magnetic Properties of Ndxfe60.5-Xpt39.5 (X=0, 0.5, 1.0, 1.5) Alloys

Anomalous phase transformation in magnetostrictive Fe81Ga19 alloy

Phase Transformations after Heat Treating an As-Cast Fe-30Mn-8.8Al-0.3Si-0.15C Steel

Phase Transformation and Magnetic Properties of Mechanically Alloyed Ndfe12-Xmoxny

Phase Transformation Of Beta-Fesi2-Based Alloys Under In-Situ High-Temperature And High-Pressure X-Ray Diffraction Measurements

The Amorphous-To-Nanocrystalline Transformation In Fe73.5cu1nb3si13.5b9 Studied By Thermogravimetry Analysis