Abstract:Journal of Composite Materials, Ahead of Print. Carbon/carbon (C/C) composites have strict requirements for their thermal properties in extreme environments, especially at high temperature, where their properties are crucial for long-term life. The structure of C/C composites is exceptionally complex and exhibits multi-scale characteristics, and their thermophysical properties are closely related to temperature. Therefore, exploring their thermal response and heat transfer mechanisms through experimental method is relatively costly. This paper constructs a multi-scale finite element model to investigate the influence of structure and manufacturing defects on performance, and analyzes the thermophysical properties of the composites at High-temperature. By constructing a micro-representative volume element (Micro-RVE) that includes fibers, matrix, and pores, and using a steady-state heat transfer analysis method, the influence of material phase distribution on performance is studied. At the same time, a Meso-RVE reflecting the layering form, needle punching effect and manufacturing defects is established, and the transient heat transfer analysis method is used to investigate the influence of the structural form on performance. Finite element analysis shows that, the simulation values of the three C/C composites of unidirectional fiber bundles, short-chopped fiber felts, and needle punched C/C composites show good consistency with the experimental results in the published literature. This paper uses numerical methods to calculate the thermophysical properties of C/C composites from room temperature to 900°C and explores their variation with temperature. The constructed multi-scale model provides an accurate and effective method for predicting the thermophysical properties of C/C composites and also provides new perspectives and insights for thermal-mechanical coupling analysis and structural design.

Effective Elastic Properties of 3d Carbon-Carbon Composites at High Temperature

Fabrication of Three-dimensional Thermally Conductive Carbon Fibers/Carbon Nanotubes Network Reinforce Epoxy Composites

A Numerical Study on the Thermal Conductivity of 3D Woven C/C Composites at High Temperature

Multi-scale Modeling of Thermal Expansion Coefficients of C/C Composites at High Temperature

Theoretical Analysis of Thermophysical Properties of 3D Carbon/Epoxy Braided Composites with Varying Temperature

Multi-scale modeling: Finite element analysis of the thermophysical properties of carbon/carbon composites considering manufacturing defects and porosity at high temperature

High-temperature constitutive model for three-dimensional needled C/C-SiC composite under tensile loading

Mechanical Behavior of carbon felt-carbon composites under ultra-high temperature

The temperature effect on the inter-laminar shear properties and failure mechanism of 3D orthogonal woven composites

Computational Study of the Nanoscale Mechanical Properties of C-S-H Composites under Different Temperatures

Elevated temperature effect on tension fatigue behavior and failure mechanism of carbon/epoxy 3D angle-interlock woven composites

Effects of temperature and strain rate on impact compression behaviors of three-dimensional carbon fiber/epoxy braided composites

A hierarchical multiscale model for the elastic-plastic damage behavior of 3D braided composites at high temperature

Study on mechanical properties and thermal conductivity of 3D short carbon fiber reinforced ultra-high temperature ceramic matrix composites: A novel material performance evaluation model

Flexural Properties of Carbon-Carbon Composites at Temperatures Up to 2600 °C

A temperature-dependent constitutive model for fiber-reinforced ceramic matrix composites and structural stress analysis

High-fidelity prediction and temperature-rise mechanism for low-velocity impact of triaxially braided composites

Tensile Properties of Two-Dimensional Carbon Fiber Reinforced Silicon Carbide Composites at Temperatures Up to 2300 °C

EXPERIMENTAL INVESTIGATION ON MECHANICAL PROPERTIES OF HYBRID CARBON-CARBON COMPOSITES AT ULTRA-HIGH TEMPERATURE

An elastoplastic mechanical-thermal model for temperature rise simulation of two-dimensional triaxially braided composites under quasi-static loads

Thermo-elastic properties in short fibre reinforced ultra-high temperature ceramic matrix composites: Characterisation and numerical assessment