Abstract:Abstract Significant pressure fluctuation may exists at the inlet of the draft pipe during load shedding of water pump and turbine sets. When the tail-water level is low, the minimum water hammer pressure at the inlet of the draft pipe set is higher than evaporation pressure; however, the overall pressure after superposition with pulsating pressure may reach the evaporation pressure in an instant. In these cases, it is unknown if a cavity is formed or water column separation is induced. It is also unknown how frequency and amplitude of the pulsating pressure affect the formation of cavity or water column separation. However, in terms of the physical formation of water column separation, liquid pressure reaching evaporation pressure is only the necessary condition of water column separation rather than a sufficient condition because the growth and aggregation of cavitations take time. In addition, water column separation could be induced only when the cavitation rate in the water reaches a specific value and gas-liquid relative motion occurs. In this study, based on the uniform cavitation distribution model, the critical of flow velocity gradients are calculated both in front and at the back of the section and are the sufficient condition of water column separation. This study uses the criterion of when the ratio of the vaporous cavitation volume to the volume of the pipe segment with a length of Δx exceeds a critical cavitation rate for classifying water column separation segments and non-water column separation segments. In water column separation segments, a concentrated vaporous cavitation model is used for calculation; however, dynamic meshes should be applied for tracking the change of vaporous cavitations. In the non-water column separation segments, the vaporous cavitation volume can be calculated according to the continuity equation but is converted into a cavitation rate in the pipe segment and substituted into gas-liquid two-phase equation to calculate wave velocity. Next, a case study was performed on a pipe-valve system. By taking into account the pulsating pressures with different frequencies and amplitudes on the downstream side in the valve closing process, water column separation and merging processes were analyzed and the change in flows, cavitation volumes and pressures on various sections and their laws during the transient process were concluded.

Pressure wave transmission at an air-cushion surge chamber

Numerical Study of the Internal Fluid Dynamics of Draft Tube in Seawater Pumped Storage Hydropower Plant

A Simulation Study of Hydraulic Vibration caused by Clearance Flow in a Pump Turbine

Analytical Study on Water Hammer Pressure in Pressurized Conduits with a Throttled Surge Chamber for Slow Closure

An experimental investigation into the wave power extraction of a floating box-type breakwater with dual pneumatic chambers

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Dynamic Interaction Between Valve-Closure Water Hammer Wave and Centrifugal Pump

Analytical Model of Unsteady Internal Water Pressure Propagation along Cracks in Hydropower Tunnel Walls

Cushion Process of the Hydraulic Cylinder of Hydraulic Operating Mechanism for High Voltage Circuit Breaker

Evolution mechanism of water column separation in pump turbine: Model experiment and occurrence criterion

Investigation of water column separation induced by pressure pulsation based on critical cavitation rate model

Analytical solution for wave-induced hydraulic response on subsea shield tunnel

Effect of errors in predicting the water hammer types and pressures in a simple pipeline

The influence of peak of wave-channel clearance on performance characteristics of traveling wave turbine

Pressure Analysis in the Draft Tube of a Pump-Turbine under Steady and Transient Conditions

The Impact of Water Hammer on Hydraulic Power Units

Acoustic wave propagation in high-pressure system

Multiple wave scattering by submerged obstacles in an infinite channel of finite depth with surface pressure excess

Cavitation pressure fluctuation characteristics of a prototype pump-turbine analysed by using CFD

Pressure fluctuation characteristics of a pump turbine in a draft tube: New insight into water column separation

Fluctuation in the Water Level of the Air Hole of the Gate Shaft in the Pumped Storage Power Station