Abstract:Seven carbon particle diameters, ranging from 0.006 to 16mm; three air temperatures, varying from 1000 to 1800K; four ambient air velocities, namely, 0, 0.5, 5, and 50m/s respectively, are selected to study carbon combustion numerically. Three-dimensional time-dependent numerical procedure is employed. The carbon particle is situated in the center of the computational domain and remained at rest. A uniform computational grid which is eight times larger than the original particle diameter in every coordinate axis is adopted. Three carbon combustion regimes, namely kinetic-controlled, kinetic-diffusion-controlled, and diffusion-controlled, are all observed. To analyze these carbon combustion regimes quantitatively, the kinetic-controlled carbon combustion is defined as that the minimum oxygen concentration at the carbon surface is greater than 90% of the ambient oxygen fraction solving with single-film model; the diffusion-controlled carbon combustion is defined as the minimum oxygen concentration on the carbon surface is less than 10% of the ambient oxygen fraction solving with single-film model too. Other ranges are defined as kinetic-diffusion-controlled carbon combustion. Two quantitative curves, one is to distinguish the kinetic-controlled and kinetic-diffusion-controlled carbon combustion, the other is to distinguish the kinetic-diffusion-controlled and diffusion-controlled carbon combustion, are obtained. The carbon burn-off time is also studied in this paper; the results show that when carbon particle diameters are less than 0.24mm and the corresponding air temperature is chose 1400K, the carbon combustion regimes are closer to kinetic-controlled. Another discovery is that higher relative air velocity does not always give rise to less burn-off time.

Study on the burning rate of carbon particle under forced convection

RESEARCHES ON THE IGNITION REGULATION OF THE PULVERIZED COAL-AIR FLOW IN A TUBE

THE EFFECT OF FORCED CONVECTION ON MASS AND HEAT TRANSFER DURING SINGLE COAL PARTICLE COMBUSTION

Simulation of Combustion Process for Two Carbon Particles

Particle Combustion Model Simultaneously Considering A Volatile and Carbon Reaction

Exploring the Combustion Mechanism of Single Micron-Sized Aluminum Particles with a Numerical Model

Drag Force for a Burning Particle

Numerical Simulation Method and Experimental Validation of a Single Char Particle Combustion Model in Bulk Space

Modelling the Combustion of Thermally Thick Biomass Particles

Modeling of Single Coal Particle Combustion in O2/N2 and O2/CO2 Atmospheres under Fluidized Bed Condition

Quasi-steady and Transient Combustion of a Carbon Particle: Theory and Experimental Comparisons

Three-dimensional Time-Dependent Numerical Simulation of a Quiescent Carbon Combustion in Air

A New Flame Sheet Model to Reflect the Influence of the Oxidation of CO on the Combustion of a Carbon Particle

Modeling Droplet Vaporization and Combustion with the Volume of Fluid Method at a Small Reynolds Number

Modeling Research On Char Particle Combustion Behavior In Cfb Condition

Computational modeling of oxy-coal combustion with intrinsic heterogeneous char reaction models

Effect of particle distance on combustion behaviors through 1-D model with Neumann boundary condition

Numerical study on flame propagation of nano- and micron-sized aluminum dust combustion in air

Study on Characteristics of Coal Chars Combustion in O_2/CO_2 at High Temperatures Based a Nonlinear Diffusive Model

Numerical simulation of burning process of counterflowing streams

Study on the Selection for Micro-combustion Simulation Model