Abstract:The irreversibility of the thermoelectric cooling (TEC) model could analyze and optimize refrigeration performance. In present work, a one-dimensional thermal conductivity model of the internal irreversible thermoelectric element was first established. Subsequently, two categories of evaluation indexes were further analyzed, i.e., cooling capacity Q c and coefficient of performance (COP). The thermodynamic model of TEC was then established jointly with finite time thermodynamics. The influences of current and the ratio of heat transfer areas between cold and hot sides on the steady-state characteristics of TEC were further discussed under Newtonian linear heat transfer. In addition, a transient thermodynamic model of TEC equipment was built to compare the effects of pulse width, pulse gradient, and pulse current on the cold side temperature of the TEC module. Theoretical results demonstrated that the effective working range of the steady-state operating current is 2A ≤ I ≤ 25A, and the area ratio of heat transfer between cold and hot sides is 0.07 ≤ x ≤ 1. The cooling capacity ( Q c ) and coefficient of performance (COP) could reach up to about 50W and 2.0, respectively. In addition, the increase of external heat transfer capacity of the hot side could reduce the transient supercooling temperature and the peak overshoot temperature, simultaneously. Afterward, the cooling capacity was remarkably enhanced. Current research could provide a reliable support for the optimization design and performance improvement of the thermoelectric cooler. Thermal conductivity model of internal irreversible thermoelectric element was established; Effects of cold and hot ends on the TEC were discussed under Newtonian linear heat transfer; Effects of pulse width, gradient and current on TEC cold end temperature were investigated; Heat transfer capacity of TEC hot end could reduce supercooling and overshoot temperatures; The irreversibility of TEC model will enhance its potentials for low grade energy exploitation.

The Maximum Coefficient of Performance of Thermoelectric Heat Pumps

Optimal Criteria for Different Parameters of an Irreversible Regenerative Intercooled Brayton Cycle under Maximum Power and Maximum Ecological COP Conditions

Theoretical Study of a Thermoelectric-Assisted Vapor Compression Cycle for Air-Source Heat Pump Applications

Thermodynamic Analysis on a Two-Stage Transcritical CO2 Heat Pump Cycle with Double Ejectors

Design Optimization of Thermoelectric Cooling Systems for Applications in Electronic Devices

A Theoretical Study of an Innovative Ejector Enhanced Vapor Compression Heat Pump Cycle for Water Heating Application

Optimum allocation of heat transfer surface area for heating load and COP optimisation of a thermoelectric heat pump

Performance Evaluation and Optimization of Air-to-Air Thermoelectric Heat Pump System

Maximum power and the corresponding efficiency for a Carnot-like thermoelectric cycle based on fluctuation theorem

Optimum Allocation of Heat Exchanger Area of a Thermoelectric Heat Pump

Thermodynamic Performance of a Brayton Pumped Heat Energy Storage System: Influence of Internal and External Irreversibilities

Thermodynamic properties of non-azeotropic refrigerant heat pumps under full operating conditions with non-phase-change heat sinks and heat soucres

THERMODYNAMICS MODEL AND PERFORMANCE OPTIMIZATION OF ABSORPTION HEAT PUMP

General thermodynamic performance of irreversible absorption heat pump

Performance optimization of a class of combined thermoelectric heating devices

Power and Thermal Efficiency Optimization of an Irreversible Steady-Flow Lenoir Cycle

Multi-parameters Analysis and Optimization of a Typical Thermoelectric Cooler Based on the Dimensional Analysis and Experimental Validation

A Model to Evaluate the Device-Level Performance of Thermoelectric Cooler with Thomson Effect Considered

Thermodynamic Performances of Coupled Autonomous Heat Devices: Insights from the Trade-off Optimization

Power and efficiency optimizations of an irreversible regenerative organic Rankine cycle

Irreversibility of thermoelectric cooling model: Newtonian linear heat transfer and finite time thermodynamics