Abstract:Spectroscopy based methods have proven great potential in efficient, non-invasive material characterization. Recording the material-specific optical properties delivers instant information on the composition of an investigated sample surface without chemical sample preparation and may be operated in spatially continuous mode.&#160;In minerals, laser-induced fluorescence (LiF) provides a promising method to address the challenges of robust and efficient rare-earth element (REE) detection.&#160;The method is based on the characteristic electronic transitions within the incompletely filled f-shell of REE. The corresponding emission shows distinct features (spectral fingerprints) in the visible and near-infrared (VNIR) range of the electromagnetic spectrum that allow to distinguish between individual REE and mineral matrix luminescence. Only REE with completely filled or empty f-orbitals miss characteristic luminescence (i.e. Y3+, Sc3+, La3+, Lu3+), while the emissions of Gd3+ lie at lower wavelengths than the observed VNIR range.We test the suitability of LiF in applications of REE identification by (1) building a spectral LiF library from a sample set of luminescent REE phosphates and (2) evaluating observed emissions in samples of non-luminescent REE, and (3) comparing indicated REE cross-contamination to results of neutron activation analysis (NAA). As samples, we use the Smithsonian REE phosphate standards for electron microprobe analysis. The synthetic material delivers a simple, well-defined host composition, is well investigated and NAA results are available on additional trace REE concentration resulting from the material production procedure. The trace REE concentrations are at the order of 10-4 given in mass fraction. We employ laser-induced fluorescence at three commonly used laser wavelengths (325 nm, 442 nm, 532 nm) to acquire our REE sample spectra and record LiF signals in the visible to near-infrared spectral range (350 &#8211; 1080 nm).The comparison of spectra from non-luminescent REE phosphates shows clear similarities in emission patterns that can be assigned to specific luminescent REE using the spectral LiF library. Our results demonstrate the suitability of LIF for REE detection along with the benefits of selective element excitation and highlight the high sensitivity of the LiF method. The detected emissions in the non-luminescent samples indicate a detection limit below mass fractions of 10-4, when compared to NAA results, but also show that not all REE are equally responsive. Here, the co-existence of REE with complex interactions such as charge transfer contributes to the observed emission pattern.&#160;Adding to the spectral LiF library data and expanding investigations to further mineral hosts will facilitate new applications of LIF for REE analysis in natural samples and its implementation in raw material exploration.

Research of leafs' application in trace Au analysis in marine deposit

Quantitative Analysis of Cadmium and Zinc in Algae Using Laser-Induced Breakdown Spectroscopy

In-situ auto-analysis technique of trace heavy metal in seawater

[Analysis of Trace Pd in Marine Deposit Samples Using Laser-Excited Atomic Fluorescence Spectrometry].

Advances in laser-excited atomic fluorescence spectrometry

8.2.2 A High Spatial Resolution MEA for Voltammetric Analysis of Trace Metals in Water Pollution Based on Partial Least Squares Regression

Quantification of ultra-trace organolead species in environmental water by inductively coupled plasma mass spectrometry with online solid-phase extraction and high performance liquid chromatographic separation

X-ray energy spectrum analysis of heavy metals distribution in the cells of animal and plants

Research progress on the application of laser-induced breakdown spectroscopy in metal element detection

Methods of Data Processing for Trace Elements Analysis Using Laser Induced Breakdown Spectroscopy

Trace Element Analysis of Aqueous Samples by Laser-Induced Breakdown Spectroscopy Based on Pre-Concentration of Electrospray

Chip-Based Capillary Electrophoresis On-Line Coupled with Atomic Fluorescence Spectrometry and Its Application to Rapid Speciation Analysis

Application of XRF scanning to different geological archives

Spectral enhancement and quantitative accuracy improvement of trace metal elements in aqueous solutions using electrostatic-assisted laser-induced breakdown spectroscopy

Ultrasensitive Determination of Gold in Geogas by Laser Excited Atomic Fluorescence Spectrometry

Detection and quantification of Pb and Cr in oysters using laser-induced breakdown spectroscopy

Trace level enrichment of lead from environmental water samples utilizing dispersive liquid-liquid microextraction and quantitative determination by graphite furnace atomic absorption spectrometry

Fabrication and Characterizations of Axial View Liquid Electrode Plasma Atomic Emission Spectrometry for the Sensitive Determination of Trace Zinc, Cadmium, and Lead

Laser-induced fluorescence (LiF) spectroscopy for detecting REE cross-contaminations in the Smithsonian rare-earth element phosphate standards

Determination of manganese, nickel, copper, zinc, lead, rubidium and strontium in geogas samples by total reflection x -ray fluorescence spectrometry

Analysis Of Trace Metals By Capillary Electrophoresis