Abstract:A series of K-ZrO2/Cu/Al2O3 catalysts (KZC(T)A (T= 600-900 degrees C)) were prepared by a sequential impregnation method and investigated for the direct synthesis of ethanol and isobutanol from syngas. The calcination temperature for C(T)A (T= 600-900 degrees C) preparation had considerable effect on the structure and catalytic performance of KZCTA catalysts. By increasing the calcination temperature from 600 to 900 degrees C, the CO conversion was promoted obviously from 20.3 to 53.0%. When the calcination temperature was lower, KZC(700)A catalyst showed high isobutanol selectivity of 17.7 wt%, while only a small amount of isobutanol was obtained in the reference catalysts of KZA and KC(700)A without Cu or Zr as promoters. The coexistence of Cu and Zr in the catalyst was required for isobutanol formation. Furthermore, the Cu-ZrO2 interface amounts increased firstly with the increase of calcination temperature and then decreased at over-higher calcination temperature because of the aggregation of ZrO2. The isobutanol selectivity changed with the Cu-ZrO2 interface amounts in catalyst, suggesting that the Cu-ZrO2 interfaces were responsible for isobutanol preferable synthesis directly from syngas. In addition, ethanol selectivity increased clearly up to 36.3 wt% when the higher calcination temperature 900 degrees C was employed for catalyst preparation. In comparison with the KZC(900)A catalyst, the catalyst of KC(900)A prepared without Zr as promoter exhibited excellent catalytic performance for the ethanol synthesis (33.5 wt%). It revealed that Zr cannot contribute to ethanol formation, and the newly formed CuAlO2 phase under higher calcination temperature in the catalysts possibly favored ethanol formation. As confirmed by XRD, Raman spectroscopy and H-2-TPR, the CuAlO2 phase emerged and its amount increased with the increase of calcination temperature for catalyst preparation. A good linear relationship was found between ethanol selectivity and the amount of CuAlO2, proving that the CuAlO2 phase acted as efficient active sites for ethanol preferable synthesis directly from syngas.

Preparation and characterization of ultrafine particle CuO/ZrO2 catalysts II. Effect of calcination temperature on the morphology of the catalyst

Preparation and characterization of ultrafine particle CuO/ZrO2 catalysts I . Effect of hydrogel pH value on the morphology of the catalysts

Microstructure Characters of Cu/ZnO Catalyst Precipitated Inside Microchannel Reactor

A gel-oxalate co-precipitation process for preparation of Cu/ZnO/Al2O3 ultrafine catalyst for methanol synthesis from CO2+H2: (II) effect of various calcination conditions

Structural Evolution and Catalytic Properties of Nanostructured Cu/Zro2 Catalysts Prepared by Oxalate Gel-Coprecipitation Technique

Influence of Calcination Temperature on the Dispersion Behavior and CO Oxidation Properties of CuO/γ-Al<SUB>2</SUB>O<SUB>3</SUB> Catalyst: Influence of Calcination Temperature on the Dispersion Behavior and CO Oxidation Properties of CuO/γ-Al<SUB>2</SUB>O<SUB>3</SUB> Catalyst

Influence Of Calcination Temperature On The Dispersion Behavior And Co Oxidation Properties Of Cuo/Gamma-Al2o3 Catalyst

In-situ Formed Stable Pt Nanoclusters on Ceria-Zirconia Solid Solutions Induced by Hydrothermal Aging for Efficient Low-Temperature CO Oxidation

The Effect of Calcination Temperature on the Structure and Activity of TiO2/SiO2 Composite Catalysts Derived from Titanium Sulfate and Fly Ash Acid Sludge

Surface active structure of ultra-fine Cu/ZrO2 catalysts used for the CO2+H2 to methanol reaction

The Nature of Cu/ZrO2 Catalyst: Experimental and Theoretical Studies

Effects of Calcination Temperature on Structure-Activity of K-ZrO2/Cu/Al2O3 Catalysts for Ethanol and Isobutanol Synthesis from CO Hydrogenation

Preparation and Microstructure of CuO-CoO-MnO/SiO2 Nanocomposite Aerogels and Xerogels As Catalyst Carriers

The effect of CuO crystallite size on the structure and performance of CuZnAl catalyst for mixed alcohols synthesis from syngas

CO2 Hydrogenation to Methanol over Cu/ZnO/ZrO2 Catalysts Prepared Via a Route of Solid-State Reaction

Effect of ceria on structure and thermostability of copper-iron-oxide catalyst

Preparation and characterization of CuO–ZrO2 nanopowders

Influences of preparation methods of ZrO2 support and treatment conditions of Cu/ZrO2 catalysts on synthesis of methanol via CO hydrogenation

Preparation and structural characterization of SiO2-ZrO 2 aerogels

Microcalorimetric and infrared spectroscopic studies of γ-Al2O3 modified by zinc oxide

Preparation and properties of ultrafine SO4 2- /ZrO2 superacid catalysts