Abstract:In the LF refining process, argon blowing at the bottom of ladle can play an important role in unifying the composition and temperature of molten steel and removing inclusions. However, unreasonable bottom argon blowing process can also cause many problems. Slag entrapment and slag surface exposure may occur, affecting the steel quality. Since the working conditions of different enterprises are very different, corresponding optimization is required for specific parameters. There were some problems in 70t ladle of a steel plant, such as unclear control of bottom argon blowing system in different refining periods, unobvious floating removal effect of inclusions in ladle, high total oxygen content and large fluctuation, etc. In this study, a 1:3 physical model was established according to the similarity principle. Then, on this basis, the experimental schemes with different blowing hole positions and argon flow rates were designed for simulation experiments. By means of mixing time measurement, flow field display and oil film measurement, the optimal argon blowing position was double holes 6, 12 (2/3R), and the included angle between them was 135°. The optimal argon flow rate for wire feeding and soft blowing should be 7.6 L/min (corresponding to the actual production of 180 L/min) and 0.6 L/min (corresponding to the actual production of 15 L/min), respectively. According to this scheme, the industrial experiments showed that the contents of total oxygen and nitrogen in the whole process were reduced, the surface density of inclusions in billet was reduced by 11.81% on average, and calcium sulfide and various inclusions containing aluminum were reduced to varying degrees.

Simulation of high purity argon process flow

Performance Design of a Cryogenic Air Separation Unit for Variable Working Conditions Using the Lumped Parameter Model

Simulation of Industrial Catalytic Reforming Process by Developing User's Module on ASPEN PLUS Platform

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Complete Equation-Oriented Approach for Process Analysis and Optimization of A Cryogenic Air Separation Unit

Simulation for Separation of Oxygen and Nitrogen from Air

Aggregate Models Based On The Wave Propagation Theory For High-Purity Distillation Columns

Numerical Simulation on Dehydrogenation Behavior during Argon Blowing Enhanced Vacuum Refining Process of High-quality Steel

Atomistic-Continuum Hybrid Simulation of Heat Transfer between Argon Flow and Copper Plates

Numerical Simulation of Heat Transfer and Fluid Flow of a Non-Equilibrium Argon Plasma Jet with Confined Wall

Simulation research on the flow field performance of the supersonic separator for natural gas

CFD Simulation of Flow Field,temperature Field and SO2 Absorption in Flue Gas Quench Tower

Development of Mathematical Model and Optimal Control System of Air Separation Process for Improving Argon-Yield Rate

Design and numerical analysis of a novel argon gas tube to reduce impurities in large size casting crystalline silicon furnace

Numerical Simulation of Gas Quenching Process of Workpiece

Simulation for Naphtha Pyolysis in Clear Radiation Tube of SRT-IV Cracking Furnace

The steady-state and dynamic simulation of cascade distillation system for the production of oxygen-18 isotope from water ☆

Physical Simulation Study on Flow Field Characteristics of Molten Steel in 70t Ladle Bottom Argon Blowing Process

ASU Simulation in Separating Air Components by Refrigeration Distillation (Oxygen and Nitrogen) Using ASPEN HYSYS (Case Study: SIAD Company)

Simulation of Rarefied Gas Flows in Atmospheric Pressure Interfaces for Mass Spectrometry Systems

Numerical simulation of concentration distribution in membrane separator cascade for producing high purity gas