Abstract:Design considerations concerning the maximum purity of a membrane separator, and the resultant maximum effective selectivity of the membranes were explored by modeling a binary gas membrane separator (pressure-driven permeance) using a dimensionless form. Although the maximum purity has an analytical solution at the limit of zero recovery or stage cut, this solution over-predicts the obtained purity as the recovery is increased. Furthermore, at combinations of high recovery, low feed mole fraction, and low pressure ratio, the maximum purity becomes independent of selectivity above some critical selectivity. As a consequence of this purity limitation, a maximum selectivity is defined at which further increases in selectivity will result in less than a 1% change in the final purity. An equation is obtained that specifies the region in which a limiting purity is less than unity (indicating the existence of a limiting selectivity); operating at less than the limiting pressure ratio results in a purity limitation less than unity. This regime becomes larger and more significant as the inlet mole fraction decreases (e.g., inlet feed mole fraction of 10% and pressure ratio of 100 results in a maximum useful membrane selectivity of only 130 at 95% recovery). These results suggest that membrane research should focus on increasing permeance rather than selectivity for low-concentration separations. The results found herein can be used to set benchmarks for membrane development in various gas separation applications.

Numerical simulation of concentration distribution in membrane separator cascade for producing high purity gas

Dynamic Simulation of Parameter for Membrane separator Cascade with Intermittent Impurity withdrawal

Process optimization of CO2membrane and cryogenic hybrid separation

Modelling and Simulation of Two-Bed PSA Process for Separating H2 from Methane Steam Reforming

Simulation research on the flow field performance of the supersonic separator for natural gas

Research Progress of Membrane Contactor for Gas Separation

Modeling, Characteristic Analysis, and Optimization of Ideal Internal Thermally Coupled Air Separation Columns

Theoretical and Experimental Study of a Non-stationary Isotope Separation Process in a Gas Centrifuge Cascade

Simulation Research of Isotope 13 C Separation by Double-stage Cascade

Integrated design of multi-stage membrane separation for landfill gas with uncertain feed

Numerical analysis of a novel cascading gas-liquid cyclone separator

On the Maximum Obtainable Purity and Resultant Maximum Useful Membrane Selectivity of a Membrane Separator

Numerical Simulation of Membrane Separation Characteristics of Supercritical Carbon Dioxide and Water

Modeling the mass transfer process in membranes for carbon capture and separation with concentration polarization effect

Numerical simulation of structural optimization within a supersonic cyclone separator

The steady-state and dynamic simulation of cascade distillation system for the production of oxygen-18 isotope from water ☆

Control Method of Feed Gas Flux in Membrane Separation Process

Numerical Simulation of Carbon Separation with Shock Waves and Phase Change in Supersonic Separators

Experimental Investigation on the Separation Characteristics of the Novel Combined Separator

Membrane Separation Process Modeling for CO2 Partial Removal in Prepurification of Air Separation Units

Simulation and Experimental Validation of a New Separator Design for a Wide Range of Gas Volume Fractions