Abstract:An experimental and theoretical method of triboanalysis is proposed to characterize the antifriction properties of polyamides and composites based on them, used in self-lubricated metal-polymer sliding bearings. The indicators of wear resistance of the materials are determined experimentally. The generalized parameters of the mathematical model of wear used in the design of metal-polymer bearings are calculated. The dependences (diagrams) of wear resistance of unfilled polyamides PA6, PA66, and polyamide composites PA6 + 30GF, PA6 + 30CF, PA6 + MoS 2 , and PA6 + oil paired with steel 45 on specific friction force are obtained and a comparative assessment of the wear resistance is given. The influence of contact pressure on the friction coefficient is studied and a significant decrease in the latter with increasing contact pressure is shown. A decrease in the Vickers hardness and elastic modulus of the surface layer of the studied materials during wear is also established. It is more significant for unfilled polyamide PA66 (by 1.66 times), PA6 + 30CF (by 1.5 times), PA6 + MoS 2 (by 1.41 times), and less noticeable for polymer composites PA6 + 30GF and PA6 + oil by 1.21 and 1.09 times, respectively. The fact should be taken into account in tribological calculations of metal-polymer sliding bearings. The research results are presented in the form of diagrams, which allow one to compare the wear resistance of the investigative materials in a wide range of specific friction forces. Thus, the practical significance of the results lies in the possibility of their use in tribological engineering to predict the service life of metal-polymer plain bearings and validate the choice of antifriction materials for their manufacturing.

Study on friction behavior of wear-resistant PA-6 alloy

The mechanical and tribological properties of CF/PPS composite filled with PA6

Effect of crystalline form on the tribological properties of PA46/HDPE polyblends

Correlation between the characteristics of the thermo-mechanical mixed layer and wear behaviour of Ti–6Al–4V alloy

Tribological Behaviors of Several Polymer–polymer Sliding Combinations under Dry Friction and Oil-Lubricated Conditions

The Relationships Between Tribological Behaviour and Heat-Transfer Capability of Ti6Al4V Alloys

Tribological Behavior of Polyamide 66‐based Binary and Ternary Composites

Experiment Study on Friction Behaviour of Ti-6Al-4V Alloy for Hot-working

Study on tribological properties of frictional material based aromatic polyamide

Uncovering wear mechanism of a Fe2Ni2CrAl multi-principal elements alloy

Morphology and Microstructure of Polyamide 46 Wear Debris and Transfer Film: in Relation to Wear Mechanisms

Research on Sliding Wear Behavior of Co-based Alloy Based on Experiments with Material of Pin and Disc Exchanged

Mechanical and Tribological Properties of PA/PPS Blends

Mechanical And Tribological Properties Of Paws Blends

Effect of Reinforcement with Short Carbon Fibers on the Friction and Wear Resistance of Additively Manufactured PA12

Triboanalysis of Antifrictional Materials Based on Polyamides for Metal-Polymer Sliding Bearings

Effect and performance analysis of different surface treatments on polymer-metal friction pairs

Tribological Analysis of Engineering Plastics/Steel Friction Pairs

Dry Friction Characteristics of Ti-6Al-4V Alloy under High Sliding Velocity

Fretting Friction and Wear Behavior of Polymer Composites

Friction and Wear Characteristics of Polymer-Matrix Friction Materials Reinforced by Brass Fibers