Abstract:The purpose of this work is to measure bubble size distribution of bubbly flows in the column by using image analysis technology.Firstly,images of bubbles for a range of superficial gas velocities are obtained by using high speed camera with lighting emitting diode(LED)as a light source.Air and water are used as gas-liquid bubbly flows.Then,the images are preprocessed and converted into binary images by employing Matlab.Thus,perimeters and areas as factors of roundness are extracted to classify bubbles into overlapping and solitary bubbles.Solitary bubbles are separated to prevent the software segmenting them mistakenly.The size distribution of solitary bubbles is achieved by the use of formula.Then the overlapping bubbles are segmented into solitary bubbles by the use of an improved watershed algorithm.Finally,the size distribution of all bubbles at different gas velocities is analyzed and compared with the distribution without watershed.It shows that the size distribution with watershed is more accurate than the size distribution without watershed.The gas hold-up has also been calculated by the use of size distribution.In order to check the accuracy of the result,the calculated gas hold-up and actual gas hold-up have been compared and the measurement error between those two is expressed in the form of figure.The error grows with the increase of superficial gas velocity,less than 10% at 1.2~1.8 cm·s-1 .But the size dis-tribution obtained by the image analysis technology cannot describe the actual gas hold-up when the superficial gas velocity is more than 2.0 cm·s-1 .In spite of this,the size distribution detected can help us to learn more rules of bubble motion.For example,the growth trend of the bubble’s interfacial area slows down with the increase of superficial gas velocity.And the resulting bubble size distribution with the superficial velocity between 1.2 cm·s-1 and 2.0 cm·s-1 is shown in the form of probability density function(PDF).

Air Bubble Size Measurement in a Laboratory Flotation Cell

Study on bubble size distribution and local gas holdup in bubble column

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Bubble size and its distribution for Venturi bubble generator

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

Gas bubble behaviors in a gas–solid fluidized bed with an arch agitator

Flotation Froth Phase Bubble Size Measurement

A study of bubble size/shape evolution in microbubble countercurrent contacting flotation column

Inline imaging reveals evolution of the size distribution and the concentration of microbubbles in dissolved air flotation

Effect of micro-bubble size and dynamic characteristics on oil removal efficiency of the flotation

Bubble size distribution in cyclonic zone of a novel flotation column

Detection and analysis of bubble size distribution in liquid phase

Computer-Aided Bubble Size Control for a Swirling-Flow Bubble Generator

Bubble size distribution in a laboratory-scale electroflotation study

Investigations of bubble size distribution on swirl effervescent atomizer flotation

Reducing the Presence of Clusters in Bubble Size Measurements for Gas Dispersion Characterizations

A digital image analysis approach to understand the microscopic and macroscopic phenomena in dissolved air flotation

Three-dimensional simulation of the influence of different flotation media in the dissolved air flotation tank through the population balance model

Study of a Novel Fluidized Bed Flotation Column with Enhanced Bubble Dispersion

Microbubble-microplastic interactions in batch air flotation