Abstract:It has been widely reported that the sinter strength and heat pattern would be weakened when adopting the low grade solid fuels, such as biomass, semi-coke and anthracite. Moreover, the imbalance of heat distribution in the sintering bed is considered to be problematic on the energy efficiency. To solve the above problems simultaneously, the gaseous fuel segregation method was firstly proposed in this paper. The gaseous fuel was injected to the melting zone from the top and auto-ignited near the solid fuel combustion zone. Firstly, methane concentrations of 0.0% and 0.5% vol. were tested, keeping the total calorific heat input unchanged. The heat pattern in melting zone was recorded by both contact thermocouples and non-contact thermal infrared imager. The results indicated that the methane injection could significantly extend the melting zone from the upstream and raise the sinter strength higher than that of coke sintering, without increasing the energy Consumption. Then, the energy saving potential of the novel method was evaluated by reducing the calorific heat input 4, 6 and 8%. Furthermore, in the segregation case, the gaseous fuel injecting concentration was increased in the upper bed to enhance the weak heat pattern, and decreased in the lower bed to avoid the energy waste. It was observed that the melting zone became much more uniform in the infrared images. Finally, the optimum segregation degree of 1.0%/mm was recommended, where the sinter strength grew 2.31%. The present study provides an effective way for optimizing the energy efficiency in the sintering process. (C) 2017 Elsevier Ltd. All rights reserved.

The Optimization of Sintering Process for Alumina Extraction from Fly Ash

Mechanism and Kinetics Study of Sintering Process for Alumina Recovery from Fly Ash

Intelligent Optimization and Impact Analysis of Energy Efficiency and Carbon Reduction in the High-Temperature Sintered Ore Production Process

Optimization of sinter batching based on intelligent method of XGBoost and reverse adaptive population particle swarm optimization

Thermodynamic Analysis and Experiments on Sintering Reactions of High Alumina Flyash

Improved Optimization Method for Blast Furnace Based on Robust Soft Sensor and Process Knowledge

Alumina Extraction from Alumina Rich Fly Ash Generated from Inner-Mongolia Chinese Coal

Progress of utilization of fly ash with high concentration alumina

Study on Optimizing the Sintering Proportioning in Masteel

Exploration of Optimal Sintering Tempertature in the Preparation from Refractory Material of Fly Ash

Extraction of alumina from high- alumina fly ash desilicated residue by Low- lime sintering process

EXPERIMENT STUDY ON THE EFFECT OF IRON ORE SINTER BEHAVIOR WITH ADDING BIOMASS

Experimental Study of Extracting Alumina from Coal Fly Ash Using Fluidized Beds at High Temperature

Research on Performance Optimization of Biomass Fuel for Sintering

Dissolution of Alumina from Fly Ash Sintered Clinker

Extraction of aluminium from coal fly ash: Identification and optimization of influential factors using statistical design of experiments

Optimization of Gaseous Fuel Injection for Saving Energy Consumption and Improving Imbalance of Heat Distribution in Iron Ore Sintering

Influence of modified treatment on MSWI fly ash sintering treatment process

Effect of Sinter Mix Properties on the Flame Front Properties and Iron Ore Sintering Performance

Study on Extracting Alumina from Coal Ashes in the Coal-Fired Power Plant

Thermodynamics and kinetics of alumina extraction from fly ash using an ammonium hydrogen sulfate roasting method