Abstract:SUMMARYThe stress drop is an important dynamic source parameter for understanding the physics of source processes. The estimation of stress drops for moderate and small earthquakes is based on measurements of the corner frequency ${f_c}$, the seismic moment ${M_0}$ and a specific theoretical model of rupture behaviour. To date, several theoretical rupture models have been used. However, different models cause considerable differences in the estimated stress drop, even in an idealized scenario of circular earthquake rupture. Moreover, most of these models are either kinematic or quasi-dynamic models. Compared with previous models, we use the boundary integral equation method to simulate spontaneous dynamic rupture in a homogeneous elastic full space and then investigate the relations between the corner frequency, seismic moment and source dynamic parameters. Spontaneous ruptures include two states: runaway ruptures, in which the rupture does not stop without a barrier, and self-arresting ruptures, in which the rupture can stop itself after nucleation. The scaling relationships between ${f_c}$, ${M_0}$ and the dynamic parameters for runaway ruptures are different from those for self-arresting ruptures. There are obvious boundaries in those scaling relations that distinguish runaway ruptures from self-arresting ruptures. Because the stress drop varies during the rupture and the rupture shape is not circular, Eshelby's analytical solution may be inaccurate for spontaneous dynamic ruptures. For runaway ruptures, the relations between the corner frequency and dynamic parameters coincide with those in the previous kinematic or quasi-dynamic models. For self-arresting ruptures, the scaling relationships are opposite to those for runaway ruptures. Moreover, the relation between ${f_c}$ and ${M_0}$ for a spontaneous dynamic rupture depends on three factors: the dynamic rupture state, the background stress and the nucleation zone size. The scaling between ${f_c}$ and ${M_0}$ is ${f_c} \propto {M_0^{ - n}}$, where n is larger than 0. Earthquakes with the same dimensionless dynamic parameters but different nucleation zone sizes are self-similar and follow a ${f_c} \propto {M_0^{ - 1/3}}$ scaling law. However, if the nucleation zone size does not change, the relation between ${f_c}$ and ${M_0}$ shows a clear departure from self-similarity due to the rupture state or background stress.

The Influence of Stress Drop on Synthesized Ground Motion

Ground motion simulation for the 21 May 2021 Ms 6.4 Yangbi, China, earthquake using stochastic finite-fault method

An improved estimation of stress drop and its application on induced earthquakes in the Weiyuan Shale Gas Field in China

Synthesis of strong ground motions at two rock stations during the great Wenchuan earthquake

Synthesis of Strong Ground Motions at Two Rock Stations During the Great Wenchuan Earthquake from a Hybrid Source Model

The Stability of Ground Motions Randomly Synthesized for an Engineering Site

Analysis of the Dynamic Stress Path under Obliquely Incident P-waves and Its Influencing Factors

Using Active Source to Monitor Velocity Variation in Shallow Sediment Caused by the Wenchuan Earthquake

Stress Transfer and Its Implication for Earthquake Hazard on the Kunlun Fault, Tibet

The Relations Between the Corner Frequency, Seismic Moment and Source Dynamic Parameters Derived from the Spontaneous Rupture of a Circular Fault

Spatial and Temporal Variations of Stress Field in the Longmenshan Fault Zone after the 2008 Wenchuan, China Earthquake

Dynamic Rupture Simulations with Heterogeneous Initial Stresses Inversed from a Given Slip Distribution: A Case Study of the 2017 Mw 6.5 Jiuzhaigou Earthquake

Synthesis of Strong Ground Motions at Two Dam Sites During the Great Wenchuan Earthquake

Effects of soil sites on ground motions in the Qionghai basin in the Wenchuan great earthquake

Source Scaling, Spatially Variable Path Attenuation, and Site‐Effect Parameters via a Generalized Inversion Technique for Strong‐Motion Data from Sichuan, China

Site Dependence of Far-Source Ground Motions During the Wenchuan Earthquake

Numerical Simulation Of Earthquake Effects On Rock Slope

A Stochastic Method for Simulating Near‐field Seismograms: Application to the 2016 Tottori Earthquake

Linking the spatiotemporal distribution of static stress drops to source faults in a fluid-driven earthquake swarm, northeastern Noto Peninsula, central Japan

Stochastic modelling of ground motions for the Wenchuan earthquake using dynamic corner frequency

Source parameters and scaling relationships of stress drop for shallow crustal seismic events in Western Europe