Using Active Source to Monitor Velocity Variation in Shallow Sediment Caused by the Wenchuan Earthquake

Wang Weitao,Wang Baoshan,Ge Hongkui,Chen Yong,Yuan Songyong,Yang Wei,Li Yijin
DOI: https://doi.org/10.3969/j.issn.1001-4683.2009.03.001
2009-01-01
Abstract:Seismic velocity near the fault zone is sensitive to the stress state within that area.After the Wenchuan earthquake,in order to monitor the velocity variation near fault zone,we conducted a field experiment in the north edge of Longmenshan fault,which lasted three weeks since July 6.In the experiment,an electric hammer was used as a repeatable seismic source and the seismic signals were recorded by eight short period seismometers composed of Guralp 40T sensor and Reftek 130B digitizer.The digitizers were timing continuously with GPS to reduce timing error.We calculate the travel time variation by the combination of absolute time and cross correlation time-delay measurement.The fractal velocity variations were obtained from travel time measurement.Two prominent drops up to~2% were found,which were much more than the possible variation caused by barometric pressure change.We notice two moderate aftershocks with magnitude 4.9 and 4.7 occurring within 10km from the experiment field,when the two surface velocity drops showed up.We speculate the surface velocity drops may be caused by the coseismic effects of these two earthquakes.The theoretical calculation of the stress drop agrees with our measurement.
What problem does this paper attempt to address?