Abstract:Many attempts have been made to reproduce theoretically the stress–strain curves obtained from experiments on the isothermal deformation of highly elastic ‘rubberlike' materials. The existence of a strain-energy function has usually been postulated, and the simplifications appropriate to the assumptions of isotropy and incompressibility have been exploited. However, the usual practice of writing the strain energy as a function of two independent strain invariants has, in general, the effect of complicating the associated mathematical analysis (this is particularly evident in relation to the calculation of instantaneous moduli of elasticity) and, consequently, the basic elegance and simplicity of isotropic elasticity is sacrificed. Furthermore, recently proposed special forms of the strain-energy function are rather complicated functions of two invariants. The purpose of this paper is, while making full use of the inherent simplicity of isotropic elasticity, to construct a strain-energy function which: (i) provides an adequate representation of the mechanical response of rubberlike solids, and (ii) is simple enough to be amenable to mathematical analysis. A strain-energy function which is a linear combination of strain invariants defined by φ ( α ) = ( a 1 α + a 2 α + a 3 α –3)/ α is proposed; and the principal stretches a 1 , a 2 and a 3 are used as independent variables subject to the incompressibility constraint a 1 a 2 a 3 = 1. Principal axes techniques are used where appropriate. An excellent agreement between this theory and the experimental data from simple tension, pure shear and equibiaxial tension tests is demonstrated. It is also shown that the present theory has certain repercussions in respect of the constitutive inequality proposed by Hill (1968 a , 1970 b ).

Further Study of Rubber-Like Elasticity: Elastic Potentials Matching Biaxial Data

Obtaining Multi-Axial Elastic Potentials for Rubber-Like Materials Via an Explicit, Exact Approach Based on Spline Interpolation

A Multiaxial Elastic Potential with Error-Minimizing Approximation to Rubberlike Elasticity

Elastic behavior of bimodal poly(dimethylsiloxane) networks

A Monte Carlo Study of the Elastic Behavior of Polymethylene Chains

A Comparative Study of the Entanglement Models Toward Simulating Hyperelastic Behaviors

MULTIAXIAL STRAIN ENERGY FUNCTIONS OF RUBBERLIKE MATERIALS: AN EXPLICIT APPROACH BASED ON POLYNOMIAL INTERPOLATION

A Molecular Study on the Reinforcement of Polymethylene Elastomers

Experimental Characterization and Finite Element Modeling the Deformation Behavior of Rubbers with Geometry Defects

A Model for Rubberlike Elasticity Up to Failure

Multi-axial Strain-Stiffening Elastic Potentials with Energy Bounds: Explicit Approach Based on Uniaxial Data

Bounded Elastic Potentials for Rubberlike Materials with Strain‐stiffening Effects

Hyperelastic Behavior of Two Rubber Materials under Quasistatic and Dynamic Compressive Loadings - Testing, Modeling and Application

Large Elastic Deformations of Soft Solids Up to Failure: New Hyperelastic Models with Error Estimation

Biaxial Deformations of Rubber: Entanglements or Elastic Fluctuations?

Biaxial Deformations of Rubber: A Comparison Between Entanglement Theory and Elastic Fluctuation Theory

Calculation of Strain Energy Density Function Using Ogden Model and Mooney-Rivlin Model Based on Biaxial Elongation Experiments of Silicone Rubber

Large deformation isotropic elasticity – on the correlation of theory and experiment for incompressible rubberlike solids

A novel viscoelastroplastic constitutive model of rubber materials and parameter identification

New Compressible Hyper-Elastic Models for Rubberlike Materials

Benchmark Problems Of Hyper-Elasticity Analysis In Evaluation Of Fem