Abstract:In ITER, the metallic first mirrors (FMs) will undergo erosion due to their proximity to the fusion plasma and deposition of materials originated from the first walls (mainly beryllium). In-situ plasma cleaning is a promising technique to conserve the FMs optical properties by means of ion sputtering. In this work, the evolution of the optical properties of single-crystal (Sc) and nanocrystalline (Nc) molybdenum (Mo) and rhodium (Rh) mirrors were investigated up to 100 cycles of consecutive contamination and cleaning. Aluminum oxide (Al 2 O 3 ) was used as contaminant to replace the toxic beryllium. The plasma cleaning was carried out using a capacitively coupled argon (Ar) plasma excited by a 60 MHz radio-frequency generator resulting in the formation of a self-bias applied on the mirrors of -280 V. The plasma potential being around 30 V, the Ar ion energy was about 310 eV. The optical properties of the mirrors were assessed using ex-situ reflectivity measurements. Moreover, the surface topography was characterized by means of scanning electron microscopy (SEM), focused ion beam (FIB) and roughness measurements using atomic force microscopy (AFM). ScMo and ScRh mirrors formerly exposed to 80 successful cleaning cycles using aluminum/tungsten (Al/W) deposits and air storage exhibit drastic changes in their optical properties after being subject to cleaning cycles using Al 2 O 3 as contaminant. Additionally, freshly polished ScRh were exposed to identical cleaning cycles. All Sc mirrors exhibited pits induced by the polishing procedure using diamond paste in addition of mounds/wavy patterns. The carbon incorporated during the polishing process was demonstrated to be responsible for the pitting of the surface. The Nc mirrors preserved their initial reflectivities after up to 100 cycles. The surface topography was systematically characterized and an average erosion rate for NcRh mirrors of about 59 nm per cycle has been estimated from FIB cross-sections. The optical properties of the Nc mirrors showed a superiority in the present study in comparison to the Sc materials due to the influence of their polishing procedures.

Metal oxide coating on first mirror in fusion reactor with carbon wall

Corrosion behavior and failure mechanism of amorphous Al2O3 coating at high-temperature LBE

Study on the Microstructure and Properties Evolution of CuCrZr/316LN-IG Explosion Bonding for ITER First Wall Components

Effect of the Iter Fw Manufacturing Process on the Microstructure and Properties of A Cucrzr Alloy

The environment effect on operation of in-vessel mirrors for plasma diagnostics in fusion devices

Investigation of Liquid-Film Formation along First Wall of Laser-Fusion Reactor

Fundamental Study of Wave Propagation on Liquid Surface Related IFE Mirror

Surface modification of ITER-like mirrors after one hundred cleaning cycles using radio-frequency plasma

Morphological modification of Rh-C coatings upon low-energy Ar + ion sputtering

Advanced Self-Passivating Alloys for an Application under Extreme Conditions

New design for highly durable infrared-reflective coatings

A self-organized sandwich structure of chromium nitride for ultra-long lifetime in liquid sodium

Metallic mirror experiment with 1.6 m coating machine

Multi-staged ERO2.0 simulation of material erosion and deposition in recessed mirror assemblies in JET and ITER

Laser damage thresholds of ITER mirror materials and first results on in situ laser cleaning of stainless steel mirrors

Ultrathin protective coatings by atomic layer engineering for far ultraviolet aluminum mirrors

Development of Aperiodic Multilayer Mirrors Operated at W-Lβ Line for Plasma Diagnostics Application

Effect of intermediate layers on atomic layer deposition-aluminum oxide protected silver mirrors

Dielectric Coatings for IACT Mirrors

Reflectivity measurement of a silicon carbide mirror sample for ITER divertor vacuum ultraviolet spectrometer

Atomic-precision multilayer coating of the first set of optics for an extreme-ultraviolet lithography prototype system