Abstract:The effect of the reverse cyclic straining and the creep loading on the resultant tensile mechanical properties, such as the strength parameter (σ0.2 and σ b ), the ductile parameter (δ and ϕ f ) and the composite parameter of the strength and ductility, the static toughness (U t ), for the precipitation-strengthened nickel-based superalloy GH4145/SQ used for high-temperature turbine and valve studs/bolts in power plant was investigated systematically at a temperature of 538°C. The experimental results show that in the case of the reverse cyclic straining both σ0.2 and σ b increases at early stages of cyclic straining and, after reaching their saturated values, σ0.2 remains relatively constant until about 90% of fatigue life, while σ b exhibits continuous reduction up to a level equal to the maximum applied stress amplitude. With the increasing number of straining cycles, both δ and ϕ f as well as U t decrease significantly until final fracture. In the case of creep loading the strength parameters (σ0.2 and σ b ) tend to increase, as a whole, while the ductile parameters (δ and ϕ f ) and the static toughness (U t ) exhibit continuous decrease characterization as the amount of the creep deformation increases. The variation of the aforementioned various tensile mechanical properties during cyclic straining and creep loading of the alloy was further discussed by means of the observations of the deformation microstructures as well as the examinations of the fracture features of the specimens.

The Numerical Simulation for High Temperature Creep of the Porous Cu Alloy

Finite element simulations for high temperature compression creep of porous Cu alloy

Correlation between pore structure and compression behavior of porous sintered Cu-Ni-Cr alloy at elevated temperatures

Study on Creep Behavior and Fracture Life Prediction Method of P92 Steel Based on Finite Element Analysis

Investigation on Compressive Behavior of Cu-35Ni-15Al Alloy at High Temperatures

Unveiling the Microstructure Evolution and the Short-Time Tensile Creep Behavior in the CuCrZr Alloy

Numerical Simulation of Pore Evolution of 7050 Aluminum Alloy during Hot Compression Process

Low Cycle Fatigue and Creep Fatigue Interaction Behavior of 9Cr-0.5Mo-1.8w-v-nb Heat-Resistant Steel at High Temperature

Study on Hot Sizing and Creep-Ageing Behavior of Al-Cu-Mn Cast Alloy

Effect of High Temperature-High Pressure Treatment on Microstructure and Mechanical Properties of Cu-Cr Alloy

Influence of temperature on creep behavior, mechanical properties and microstructural evolution of an Al-Cu-Li alloy during creep age forming

An Investigation of the Effect of High-Temperature Cyclic Straining and Creep Loading on Tensile Mechanical Properties of GH4145/SQ Alloy

Numerical Simulation of High-Strength Concrete Creep under Cyclic Load

Simulation Of Porosity Effect On Mechanical And Creep Properties Of Cement

Finite element modeling of creep behavior of porous nickel alloys at the operating conditions of molten carbonate fuel cell

High temperature strain characteristics and life prediction of Sanicro25 alloy under stress-controlled cyclic loading

Microstructures and mechanical properties of Cu-Sn alloy subjected to elevated-temperature heat deformation

Simulation of Porosity Effect on Mechanical and Creep Properties of Cement Paste at Microscale

Deformation of Nanoporous Copper Subjected to High-Rate Compression at Various Temperatures

Compressive creep aging behavior and microstructure evolution in extruded Al-Mg-Si alloy under different temperature and stress levels

Effect of temperature on the creep properties of polycrystalline Cu-Ni alloy: insight from molecular dynamics simulation