Preparation of an Emulsifier for Water-in-Oil Drilling Fluid

Yuelin Yu,Xiaolin Pu,Siwen Yi,Lu Liu,Hongji Li
DOI: https://doi.org/10.3969/j.issn.1000-8144.2014.01.012
2014-01-01
Abstract:A novel emulsifier YJR-1 with heat resistance was prepared from three surfactants, namely organic acid, alkanolamide and polyether carboxylate, to improve the stability of water-in-oil drilling fluid. The emulsification performances of YJR-1 were evaluated by means of emulsion breaking voltage and near infrared scanning methods. The heat resistance of YJR-1 and the influence of the ratio of oil to water on the emulsification performances of YJR-1 were investigated. The emulsification mechanism of YJR-1 was also analyzed. The results showed that the emulsifier YJR-1 had a good performance in the emulsification and could be heat resistant at 200��C. With decreasing the ratio of oil to water, the emulsification performance of YJR-1 didn't reduce evidently. The emulsion breaking voltage of the drilling fluid with volume ratio of oil to water of 6:4 prepared with YJR-1 could reach 302 V after aging at 150��C for 16 h. The emulsifier YJR-1 can keep the stability of the drilling fluid mainly by reducing oil-water interfacial tension and forming high strength interface film.
What problem does this paper attempt to address?