Abstract:The China Fusion Engineering Test Reactor (CFETR) is a new tokamak device whose magnet system includes toroidal field, central solenoid (CS) and poloidal field coils. The main goal is to build a fusion engineering tokamak reactor with about 1 GW fusion power and self-sufficiency by blanket. In order to reach this high performance, the magnet field target is 15 T. However, the huge electromagnetic load caused by high field and current is a threat for conductor degradation under cycling. The conductor with a short-twist-pitch (STP) design has large stiffness, which enables a significant performance improvement in view of load and thermal cycling. But the conductor with STP design has a remarkable disadvantage: it can easily cause severe strand indentation during cabling. The indentation can reduce the strand performance, especially under high load cycling. In order to overcome this disadvantage, a new design is proposed. The main characteristic of this new design is an updated layout in the triplet. The triplet is made of two Nb3Sn strands and one soft copper strand. The twist pitch of the two Nb3Sn strands is large and cabled first. The copper strand is then wound around the two superconducting strands (CWS) with a shorter twist pitch. The following cable stages layout and twist pitches are similar to the ITER CS conductor with STP design. One short conductor sample with a similar scale to the ITER CS was manufactured and tested with the Twente Cable Press to investigate the mechanical properties, AC loss and internal inspection by destructive examination. The results are compared to the STP conductor (ITER CS and CFETR CSMC) tests. The results show that the new conductor design has similar stiffness, but much lower strand indentation than the STP design. The new design shows potential for application in future fusion reactors.

The performance test and analysis of the third and fourth China PF conductor for ITER

Conductor Performance of TFCN4 and TFCN5 Samples for ITER TF Coils

Performance of ITER Correction Busbar Conductor Samples CBCN2 and CBCN3

Research on Mechanical Properties of High-Performance Cable-in-conduit Conductors with Different Design

Performance Test and Analysis of the First Large-Scale Cable-in-conduit Conductor with High Jc Nb3Sn Strand for Fusion Reactor

China’s Technological Achievements on ITER Enhanced Heat Flux First Wall in the Pre-Pa Qualification

Conductor Performance of Cccn3, Cccn4, and Cccn5 Samples for Iter Cc Coils

First AC Loss Test and Analysis of a Bi2212 Cable-in-conduit Conductor for Fusion Application

New Design of Cable-in-conduit Conductor for Application in Future Fusion Reactors

Manufacture and Acceptance Test of the Full Size ITER PF5 Conductor Sample

DC Performance Measurement and Assessment of Nb 3 Sn Cable-In-Conduit Conductor for CFETR CS Model Coil

The performance test and analysis of ITER Main and Correction Busbar conductor

Study on fabrication of ITER TF conductor

Manufacture and Performance Test Result of a 95 Ka-Class Nbti Cable-in-Conduit Conductor for the Low Field Winding-Package of Cfetr-Tf Coil

Status of the ITER Conductors in China

A new enclosed method for transverse mechanical testing on CICC conductors

DC Performance and AC Loss of Sub-Size MgB2 CICC Conductor for Fusion Magnet Application

Mechanical and Electrical Properties of a CFETR CSMC Conductor under Transverse Mechanical Loadings

Fatigue tests on the ITER PF jacket

Comparison of Critical Current of Bi-2212 Cables with Disassembled Strands