Abstract:Ash aerosol and ash deposit formation during oxy-coal combustion were explored through experiments in a self-sustained 100kW rated down-fired oxy-fuel combustor. Inlet oxidant conditions consisted of 50% inlet oxygen with CO2 (hereafter denoted as OXY50 conditions). A Berner low pressure impactor (BLPI), a scanning mobility particle sizer (SMPS), and an aerodynamic particle sizer (APS) were used to obtain size segregated ash aerosol samples and to determine the particle size distributions (PSD). A novel surface temperature controlled ash deposition probe system that allowed inside and outside deposits to be separated was used to collect the ash deposits. The ash aerosol PSDs given by the BLPI and those produced by SMPS/APS were consistent with each other. Data suggested that oxy-coal combustion under these conditions did not change the formation mechanisms controlling the bulk ash aerosol composition, but it did increase the formation of ultra-fine particles initially formed through metal vaporization, due to increased vaporization of silicon at the higher combustion temperature. The smaller particles contained within the deposits had higher Si and lower Na and S concentrations under OXY50 conditions than for air combustion. Moreover, the ash aerosol composition for particle sizes less than 2.4μm was related to the composition of the inside deposits. A higher Na in the ash aerosol resulted in higher Na in inside deposits with comparable absolute Na concentrations in both those aerosol particles and those inside deposits particles. The contribution of S and Si to the inside deposits showed that S in the vaporization modes together with Si in the ultrafine vaporization mode, contributed significantly to the composition of the inside deposits. These results provided direct evidence that prediction of the chemistry of the initial deposit layer (but not of the bulk deposits) required knowledge of the size segregated chemistry of the ash aerosol.

Novel Temperature-Controlled Ash Deposition Probe System and Its Application to Oxy-Coal Combustion with 50% Inlet O-2

Measurements and Modelling of Oxy-Fuel Coal Combustion

Ash Formation and Deposition During Oxy-Coal Combustion in a 100 Kw Laboratory Combustor with Various Flue Gas Recycle Options

Ash and Deposit Formation from Oxy-Coal Combustion in a 100 Kw Test Furnace

Ash Aerosol Formation from Oxy-Coal Combustion and Its Relation to Ash Deposit Chemistry

Development of an Online Ash-Deposition Thermogravimetric Analyzer for Pulverized Coal Combustion

Impacts of oxy-fuel combustion on coal ash and deposits

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

In Situ Diagnostics on the Dynamic Processes of Ash Deposit Formation, Shedding, and Heat Transfer in a Self-Sustained Down-Fired Furnace

Experimental Study on Ash Deposition of Zhundong Coal in Oxy-Fuel Combustion

Comparison of Particulate Formation and Ash Deposition under Oxy-Fuel and Conventional Pulverized Coal Combustions

THE DEVELOPING AND APPLICATION OF A HEAT FLUX PROBE WHEN ASH DEPOSITING

Experimental study of ash formation during pulverized coal combustion in O2/CO2 mixtures

Experimental Study on Ash Deposition Characteristics of Victorian Brown Coal in Pilot- Scale Oxy-Fuel Combustion

EXPERIMENTAL STUDY OF ASH DEPOSIT DURING CO-FIRING SAWDUST AND COAL

Fine Ash Formation During Pulverized Coal Combustion - A Comparison Of O-2/Co2 Combustion Versus Air Combustion

Fly Ash Deposition During Oxy-fuel Combustion in a Bench-Scale Fluidized-Bed Combustor

Experimental investigation on ash deposition of a bituminous coal during oxy-fuel combustion in a bench-scale fluidized bed

Ash Deposition Characteristics During Oxy-Fuel Combustion of Biomass in a Drop Tube Furnace

Online Deposition Measurement and Slag Bubble Behavior in the Reduction Zone of Pulverized Coal Staged Combustion

Ash deposition during pressurized oxy-fuel combustion of Zhundong coal in a lab-scale fluidized bed