Abstract:Piles supporting transmission towers, offshore structures (such as wind turbines), or infrastructures in seismic areas are frequently subjected to either one-way or two-way cyclic lateral loadings. Relatively little attention, however, has been paid to compare and understand the effects of different loading regimes (one-way or two-way cycling) on lateral responses of piles in soft clay. For this reason, a series of field tests in soft clay are carried out to compare one-way and two-way cyclic responses of single piles and of jet-grouting reinforced piles. The field tests reveal that the single pile subjected to two-way cycling experiences much more rapid degradation in lateral stiffness and capacity, but accumulates much smaller residual pile deflection (δ p), than the single pile under one-way cycling. This is because the reverse part of the two-way cycling also generates plastic strain, causing additional softening and strength reduction in the soil surrounding the pile. After each cycling, non-zero bending moment (i.e. locked in moment, or M L) is retained in the single piles, and the M L increases with the δ p. The one-way cycling leads to two times larger M L than the two-way cycling, as it causes greater δ p. The maximum M L in the pile after one-way cycling can be up to 40% of the maximum bending moment induced during the previous cyclic loading stage. After application of jet-grouting surrounding the upper part of the single pile, it greatly reduces degradation of lateral pile stiffness, accumulation of δ p and therefore development of M L. Compared to the field measurements, the API (API RP 2A-WSD, recommended practice for planning, designing, and constructing fixed offshore platform-working stress design, 21st edn. API, Washington, 2000) code underestimates the lateral stiffness of the pile under one-way cycling, while overestimates that of the pile under two-way cycling, leading to a non-conservative prediction of bending moment in the latter pile.

Response Of 1 X 2 Pile Group Under Eccentric Lateral Loading

Large-scale model tests of 3×3 pile group under eccentric lateral loading

Dynamic response analysis for a single pile subjected to lateral loading

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Response of 3×3 Pile Groups in Silt Subjected to Eccentric Lateral Loading

Model tests on the bearing capacity of precast oxen-ended micro pipe plies in sort soil

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

TEST INVESTIGATION ON DISTRIBUTION OF INTERNAL FORCES IN PILE GROUPS UNDER DIFFERENT LATERAL ECCENTRICITIES

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

INFLUENCE OF ECCENTRICITY ON TWO-PILE FOUNDATION SUBJECTED TO LATERAL LOADING

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Analysis method for pile groups subjected to lateral and torsional loads

Analysis of Pile Groups Subjected to Torsional Loading

Group Effect in Piles under Eccentric Lateral Loading in Sand

Nonlinear Analysis of Pile Groups Subjected to Combined Lateral and Torsional Loading

Investigation of Piles Behavior under Lateral Cyclic Load

Field Testing of One-Way and Two-Way Cyclic Lateral Responses of Single and Jet-Grouting Reinforced Piles in Soft Clay

Behavior Analysis of Laterally Loaded Single Pile under Large Deflection

Centrifugal model tests on batter pile groups under eccentric lateral loads

Lateral Response Analysis of a Large‐Diameter Pile Under Combined Horizontal Dynamic and Axial Static Loads in Nonhomogeneous Soil