Abstract:The Finite Element method was used to analyze the dynamic response of pile groups in the ground subjected to the liquefaction-induced lateral flow of soils.The u-p Finite Element for-mulation was used to depict the coupling effect of water and sand soil particles in the Finite Ele-ment analysis.A 3D numerical model was developed to analyze the effect of a 2×2 pile group sub-jected to liquefaction-induced lateral spreading.In this model,sand was simulated using a pres-sure-independent multi-yield surface plastic model.Clay material served as a nonlinear hysteretic material with a multi-surface kinematic plasticity model,and the pile group maintained its linear behavior in the process of calculation.The clay layer and saturated sand layer were meshed in a 20-node brick element and separately in a 20-8 node element.The boundary of the numerical model was considered as the shear beam boundary,which simulated the shear effect of the soil layer dur-ing the earthquake.Finally,the Rayleigh damping method was used to model the damping of the system.The dynamic response of each pile in pile group was compared,and it showed that the bending moment and displacement time history of piles at different depths developed in the same way,and the time of maximum bending moment and displacement of the pile appears to lag be-hind the time of peak acceleration of the input seismic wave.The maximum bending moment and displacement of the leading pile were larger than the those of the back piles.By comparing the maximum bending moment and displacement,it can also be concluded that,as depth increases,the maximum bending moment first increases and then decreases.The bending moment of the pile at the 2.5 m depth was greater than those at other depths.In terms of displacement,as depth in-creased,the maximum pile displacement decreased,and the maximum displacement of the pile head was greater than other observed points on the pile.This demonstrated the different behaviors of the pile bending moment response.In order to consider the effect of pile spacing on the pile group effect,several Finite Element models were developed for different pile spacing.This model-ing concluded that the maximum bending moment appeared to occur in the boundary of different soil layers.As pile spacing increased,the maximum bending moment and pile head displacement in the group increased.In the pile group with pile spacing equal to 7D (diameter),the maximum bending moment of the each pile was very close.The difference was about 3% when pile spacing was equal to 5D ,and the difference was about 4%,when pile spacing was equal to 3D .The maxi-mum bending moment of the first pile group was 10% larger than the bending moment of the sec-ond pile group.In the last part of the study,the cause of the pile group effect was analyzed and a basic understanding of the seismic design requirements for this type of pile group was obtained.

Group Effect in Piles under Eccentric Lateral Loading in Sand

p-multiplier for pile groups subjected to eccentric lateral loading

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Experimental Study of Interaction and Coupling Effects in Pile Groups Subjected to Torsion

Performance of laterally loaded H-piles in sand

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Analysis method for pile groups subjected to lateral and torsional loads

Nonlinear Analysis of Pile Groups Subjected to Combined Lateral and Torsional Loading

Analysis of the Bridge Pile Group Effect in Liquefaction-induced Lateral Spreading Sites

Experimental study of pile group in sand under compressive and tensile loadings

Response Of 1 X 2 Pile Group Under Eccentric Lateral Loading

Lateral Dynamic Responses of Coastal Group Piles Considering Pile‒water‒soil Interactions

Analysis of Pile Groups Subjected to Torsional Loading

Large-scale model tests of 3×3 pile group under eccentric lateral loading

Response of 3×3 Pile Groups in Silt Subjected to Eccentric Lateral Loading

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

TEST INVESTIGATION ON DISTRIBUTION OF INTERNAL FORCES IN PILE GROUPS UNDER DIFFERENT LATERAL ECCENTRICITIES

PILE-SOIL-PILE INTERACTION BETWEEN TWO PILES MOVING ALONG DIFFERENT DIRECTIONS