Abstract:Finite Element Method (FEM) and the Statistical Energy Analysis (SEA) are standard methods in the automotive industry for the prediction of vibrational and acoustical response of vehicles. The FE method, based on a deterministic description of the dynamics is typically used for structure-borne and air-borne problems and is usually limited to below 250 Hz. The method becomes prohibitively expensive in terms of computational costs with increasing frequency as more Degrees-of-Freedom (DOF) are required to correctly represent the dynamic response of the structure. Additionally, the dynamic response becomes sensitive to small perturbations in the model, thus defeating the purpose of a deterministic modeling method. SEA is a statistical method widely applied in automotive industry for air-borne problems at frequencies higher than 300 Hz. The method is highly efficient for the design and optimization of sound packages facing airborne sources, but it lacks accuracy when dealing with structure-borne sources in the mid frequency range. However, both methods are not capable of handling the so called "mid frequency problem", where both short and long wavelength components are present in the same system. A Hybrid method has been recently proposed that rigorously couples SEA and FEM. In this work, the HybridFE-SEA method has been used to create fast/efficient model of structure-borne noise in a fully trimmed vehicle from 200Hz to 1 kHz. This paper first describes simple guidelines used to partition the vehicle into stiff components described with FE and modally dense components described with SEA. It is also demonstrated how detailed local FE models can be used to improve SEA descriptions of car panels and couplings. After review of the Hybrid FE-SEA models of a full vehicle that were built, sample experimental validation results of interior Sound Pressure Levels and panel vibration are shown for both bare and fully trimmed vehicle configurations.

Optimization of car sound package with statistical energy analysis model using grey relational analysis and taguchi method

Auto-Body Structure Noise Performance Analysis and Optimization Research

Acoustic performance design and optimal allocation of sound package in ship cabin noise reduction

Design and Optimization of Sound Package Using FE-SEA Numerical Reverberation Method

Study and Development of Subjective Evaluation of Inner Noise Quality and Improvement

Sound absorption structure optimization based on material absorption models and noise rating curves

Lightweight optimization of the front end structure of an automobile body using entropy-based grey relational analysis

Optimal design of acoustic performance for automotive air-cleaner

Coupling and Optimization Analysis of Magnesium Bulkhead and Interior Sound Field Based on SEA

Acoustic Modelling and Analysis of Vehicle Interior Noise Based on Numerical Calculation

Optimal Design of Damping Material Configuration in Vehicle

Subjective evaluation test and objective quantificational description of vehicle interior noise quality

Identification of dominant interior noise sources in micro commercial vehicle based on sound quality analyzing

Sound Insulation Numerical Calculation of an Automobile Magnesium Alloy Dash Based on FE-SEA Hybrid Method

Improving sound quality inside vehicle by active noise control method

Integrated lightweight optimization design of wall thickness, material, and performance of automobile body side structure

Damping Optimization Noise Reduction Technique Based on Modal and Panel Contribution Analysis

Optimization Layout of Damping Material Using Vibration Energy-Based Finite Element Analysis Method

Measurement and Evaluation of Sound Quality of Interior Noise of Vehicle Cabin

Acoustic optimisation design for suspension characteristics based on the method of dynamic subsystem modification

Mid Frequency Structure-Borne Noise Modeling in a Trimmed Automotive Vehicle