Abstract:ABSTRACT In this paper, a design procedure of a compact broadband microstrip diplexer working on the Very High Frequency (VHF)/Ultrahigh Frequency (UHF) band is proposed. The diplexer consists of a fourth‐order Butterworth Low‐Pass Filter (LPF) and a sixth‐order elliptic High‐Pass Filter (HPF). The two filters are located on two substrates with a common ground. A microstrip‐to‐coaxial structure is utilized to transmit the power flow between the two substrates. For miniaturization, the utilized ideal capacitors and inductors are realized by the commercial lumped‐element capacitors and the curved microstrip line sections, respectively. All the middle design and rapid optimization processes from the schematic simulation by Advanced Design System (ADS) to the circuit simulation by CST STUDIO SUITE (CST) are given in the article. A prototype is fabricated and measured. The testing results are consistent with the simulation. The diplexer can operate at 225–775 and 880–2500 MHz. The insertion losses are 0.8 ± 0.3 and 0.9 ± 0.4 dB in the two working bandwidths. The isolation bandwidth of −20 dB level is as small as 105 MHz. The roll‐off is also sharp that the related bandwidths corresponding to the attenuation level −3 to −20d B are 90 and 30 MHz to the high and low bands, respectively. Besides, the return loss and isolation are larger than 10 and 20 dB approximately. The diplexer has a volume of 0.065 λ g × 0.156 λ g @775 MHz, which can be utilized to feed the miniaturized broadband VHF/UHF antenna system.

DESIGN OF DIPLEXER WITH ROTATIONALLY SYMMETRIC STRUCTURE

Design of an Ultracompact MMI Wavelength Demultiplexer in Slot Waveguide Structures.

Collaborative Design of a New Dual-Bandpass 180 Hybrid Coupler

Design of High-Isolation Topological Duplexer Utilizing Dual-Edge State Topological Waveguides

A Multilayer Dual-Band Coupler Based on Composite Right/left-Handed Folded Substrate Integrated Waveguide

Monolithically Integrated Fiber-to-the-home Diplexers and Triplexers Using a Bilevel Etched 2×2 Optical Coupler

Design of Microstrip Multifunction Integrated Diplexers With Frequency Division, Frequency Selection, and Power Division Functions

Miniaturized Single-Ended and Balanced Dual-Band Diplexers Using Dielectric Resonators

Design of Compact Superconducting Diplexer with Spiral Short-Circuited Stubs

Design of an Ultra-Broadband Silicon Mode (De)multiplexer

Monolithically integrated FTTH diplexer using bi-level etched 2×2 optical coupler

Two-Way Waveguide Diplexer and Its Application to Diplexing In-Band Full-Duplex Antenna

A Novel Design for a Planar Microstrip Triple Diplexer With Enhanced Selectivity Using Highly-Selective Bandpass Filters

Miniaturized Wide-Stopband FSIW-LC Diplexer With High Selectivity and Narrow Channel Spacing

Flexible Design Method for Multifunctional Filtering Diplexers Integrated With Single-Pole Double-Throw Switches

Design of High-Isolation Diplexer Based on Microstrip Coupled Lines

A Novel Dieletric Slot Stripline Structure for Millimeter Wave Flexible Printed Circuit

Design and Rapid Optimization Procedure of a Compact Broadband Microstrip Diplexer for VHF/UHF Band

A Compact and High-Isolated Multiresonator-Coupled Diplexer

A novel design of 4-port diplexer with high isolation

Balanced Diplexer Based on Substrate Integrated Waveguide Dual-Mode Resonator