Abstract:In recent years, perovskite solar cell (PSC) has achieved power conversion efficiency as high as over 20 %, making it competitive with high-efficiency thin film solar cells such as CuInGaSe and CdTe solar cells. However, the critical issue of reliability and stability for PSC should be addressed since a significant degradation of photovoltaic (PV) performance at low temperature has been found regardless of planar mesoporous PSC. To reveal the degradation of PV performance in PSC, the temperature-dependent PV performance of the planar PSC is investigated in detail. A PSC sample is loaded into a cryostat chamber connected to a compressor and illuminated by a halogen lamp. The operating temperature varies from 200 K to 325 K and the current-voltage (J-V) characteristic of planar PSC is measured at different scan rates from 10 V/s to 0.0017 V/s. At a fast scan rate of 10 V/s, the PSC shows a low PV performance at either low temperature or high temperature. The short-circuit current (J(SC)), open-circuit voltage (V-OC) and maximum power point (P-MPP) are found to decline with the temperature decrteasing. Moreover, the J-V curve also shows the S-shape characteristic. This suggests that the inefficient transport of photo-generated carriers occurs in the PSC. Ions such as Pb2+, CH3NH(3+) and I-vacancies cause the screening effect of built-in field and the photo-generated carriers cannot be separated nor collected efficiently. As a result, J(SC) and V-OC show small values in J-V curves measured at a fast scan rate. However, the degradation in PV performance is temporary. The PV performance gradually reaches a steady state at different operating temperatures with scan rate going down to 0.0017 V/s. The P-MPP and V-OC increase with temperature decreasing. These results indicate that a long illumination time is necessary for PSC to reach a steady state. After long-time illumination under biased condition (i.e., J-V curves measured at slow scan rate), the built-in field is compensated for by the external bias and the ions piling in the interface regions have enough time to diffuse towards the opposite direction. Thus, the screening effect of built-in field is reduced and the PV performance of PSC reaches a steady state. According to the result of device simulation, the increasing V-OC at low temperature is attributed to the enhanced built-in potential difference and the reduced recombination rate of carriers. The temperature-dependent external quantum efficiency measurements of planar PSC before and after light illuminationis are performed to investigate the mechanism of carrier transport. It reveals that the separation and collection efficiencies of photo-generated carriers can be improved significantly after light illumination due to the fact that the screening effect of built-in field is reduced. These findings help understand the carrier transport mechanism in planar PSC.

Temperature-dependent Photovoltaic Behavior of CdSe Quantum Dots/p3ht Hybrid Thinfilm

Temperature Dependent Photovoltaic Performance of TiO2/PbS Heterojunction Quantum Dot Solar Cells

Study on the influence of embedded structure of carbon quantum dots of the organic solar cells with the territory active layer structure of P3HT: PC 61 BM: CQDs

Temperature-Dependence Photoelectrochemical Hydrogen Generation Based on Alloyed Quantum Dots

High Performance Solar Cell Based on Ultra-Thin Poly(3-Hexylthiophene): Fullerene Film Without Thermal and Solvent Annealing

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Facile Fabrication of CdS–poly(3-hexylthiophene) Hybrid Film with Improved Photo-Current Response for Heterojunction Solar Cells

Temperature-dependent Electronic Properties of Inorganic-Organic Hybrid Halide Perovskite (ch3nh3pbbr3) Single Crystal

Size Modulation and Heterovalent Doping Facilitated Hybrid Organic and Perovskite Quantum Dot Bulk Heterojunction Solar Cells

Influence of Temperature on Exciton Dynamic Processes in CuPc/C60 Based Solar Cells

Research on spectral response of CdSe quantum dots dopted polymer solar cell

Influence of Nanocrystal Size on the Quantum Dots Sensitized Solar Cells’ Performance with Low Temperature Synthesized CdSe Quantum Dots

Unveiling the Low‐Temperature Pseudodegradation of Photovoltaic Performance in Planar Perovskite Solar Cell by Optoelectronic Observation

Temperature-Dependent Time Response Characteristic of Photovoltaic Performance in Planar Heterojunction Perovskite Solar Cell

Temperature‐Insensitive Efficient Inorganic Perovskite Photovoltaics by Bulk Heterojunctions

Pbse Quantum Dot Films with Enhanced Electron Mobility Employed in Hybrid Polymer/Nanocrystal Solar Cells

Quantitative Nanoscale Monitoring the Effect of Annealing Process on the Morphology and Optical Properties of Poly(3-Hexylthiophene)/[6,6]-phenyl C61-butyric Acid Methyl Ester Thin Film Used in Photovoltaic Devices

Photophysics of Organic–Inorganic Hybrid Lead Iodide Perovskite Single Crystals

Annealing-Temperature Dependent Carrier-Transportation in ZnO/PbS Quantum Dot Solar Cells Fabricated Using Liquid-Phase Ligand Exchange Methods

Hybrid CdSe/CsPbI3 quantum dots for interface engineering in perovskite solar cells

Temperature Dependent Characteristics of Perovskite Solar Cells