Abstract:In recent years, perovskite solar cell (PSC) has achieved power conversion efficiency as high as over 20 %, making it competitive with high-efficiency thin film solar cells such as CuInGaSe and CdTe solar cells. However, the critical issue of reliability and stability for PSC should be addressed since a significant degradation of photovoltaic (PV) performance at low temperature has been found regardless of planar mesoporous PSC. To reveal the degradation of PV performance in PSC, the temperature-dependent PV performance of the planar PSC is investigated in detail. A PSC sample is loaded into a cryostat chamber connected to a compressor and illuminated by a halogen lamp. The operating temperature varies from 200 K to 325 K and the current-voltage (J-V) characteristic of planar PSC is measured at different scan rates from 10 V/s to 0.0017 V/s. At a fast scan rate of 10 V/s, the PSC shows a low PV performance at either low temperature or high temperature. The short-circuit current (J(SC)), open-circuit voltage (V-OC) and maximum power point (P-MPP) are found to decline with the temperature decrteasing. Moreover, the J-V curve also shows the S-shape characteristic. This suggests that the inefficient transport of photo-generated carriers occurs in the PSC. Ions such as Pb2+, CH3NH(3+) and I-vacancies cause the screening effect of built-in field and the photo-generated carriers cannot be separated nor collected efficiently. As a result, J(SC) and V-OC show small values in J-V curves measured at a fast scan rate. However, the degradation in PV performance is temporary. The PV performance gradually reaches a steady state at different operating temperatures with scan rate going down to 0.0017 V/s. The P-MPP and V-OC increase with temperature decreasing. These results indicate that a long illumination time is necessary for PSC to reach a steady state. After long-time illumination under biased condition (i.e., J-V curves measured at slow scan rate), the built-in field is compensated for by the external bias and the ions piling in the interface regions have enough time to diffuse towards the opposite direction. Thus, the screening effect of built-in field is reduced and the PV performance of PSC reaches a steady state. According to the result of device simulation, the increasing V-OC at low temperature is attributed to the enhanced built-in potential difference and the reduced recombination rate of carriers. The temperature-dependent external quantum efficiency measurements of planar PSC before and after light illuminationis are performed to investigate the mechanism of carrier transport. It reveals that the separation and collection efficiencies of photo-generated carriers can be improved significantly after light illumination due to the fact that the screening effect of built-in field is reduced. These findings help understand the carrier transport mechanism in planar PSC.

Unveiling the Low‐Temperature Pseudodegradation of Photovoltaic Performance in Planar Perovskite Solar Cell by Optoelectronic Observation

Temperature-Dependent Time Response Characteristic of Photovoltaic Performance in Planar Heterojunction Perovskite Solar Cell

Elucidating the Evolution of the Current-Voltage Characteristics of Planar Organometal Halide Perovskite Solar Cells to an S-Shape at Low Temperature

Comprehensive Understanding of Heat-Induced Degradation of Triple-Cation Mixed Halide Perovskite for a Robust Solar Cell

Degradation Behavior of Planar Heterojunction CH 3 NH 3 PbI 3 Perovskite Solar Cells

Understanding Temperature‐Dependent Charge Extraction and Trapping in Perovskite Solar Cells

Evolved Photovoltaic Performance of MAPbI3 and FAPbI3-based Perovskite Solar Cells in Low-Temperatures

Understanding the temperature sensitivity of the photovoltaic parameters of perovskite solar cells

Evolved Photovoltaic Performance of MAPbI3 3 and FAPbI3-based 3-Based Perovskite Solar Cells in Low- Temperatures

Self-Elimination of Intrinsic Defects Improves the Low-Temperature Performance of Perovskite Photovoltaics

Temperature‐Insensitive Efficient Inorganic Perovskite Photovoltaics by Bulk Heterojunctions

Real-Time Dynamic Observation of a Thermal and Electrical Coeffect on the Interfacial Evolution of Hybrid Perovskite Solar Cells by Electrochemical Impedance Spectroscopy

Temperature Dependent Characteristics of Perovskite Solar Cells

How Temperature Impacts Material Properties and Photovoltaic Performance of Mixed-Halide Perovskite via Light-induced Ion Migration

Heterojunction Perovskite Solar Cells: Opto-Electro-Thermal Physics, Modeling, and Experiment

Efficient Perovskite Solar Cells over a Broad Temperature Window: the Role of the Charge Carrier Extraction

Dependence of Power Conversion Properties of Perovskite Solar Cells on Operating Temperature

Interface Degradation of Perovskite Solar Cells and Its Modification Using an Annealing-Free Tio2 Nps Layer

Effect of Temperature on the Efficiency of Organometallic Perovskite Solar Cells

Degradation Mechanism of Flexible Perovskite Solar Cells: Investigated by Tracking of the Heterojunction Property

Towards linking lab and field lifetimes of perovskite solar cells