Abstract:In recent years, perovskite solar cell (PSC) has achieved power conversion efficiency as high as over 20 %, making it competitive with high-efficiency thin film solar cells such as CuInGaSe and CdTe solar cells. However, the critical issue of reliability and stability for PSC should be addressed since a significant degradation of photovoltaic (PV) performance at low temperature has been found regardless of planar mesoporous PSC. To reveal the degradation of PV performance in PSC, the temperature-dependent PV performance of the planar PSC is investigated in detail. A PSC sample is loaded into a cryostat chamber connected to a compressor and illuminated by a halogen lamp. The operating temperature varies from 200 K to 325 K and the current-voltage (J-V) characteristic of planar PSC is measured at different scan rates from 10 V/s to 0.0017 V/s. At a fast scan rate of 10 V/s, the PSC shows a low PV performance at either low temperature or high temperature. The short-circuit current (J(SC)), open-circuit voltage (V-OC) and maximum power point (P-MPP) are found to decline with the temperature decrteasing. Moreover, the J-V curve also shows the S-shape characteristic. This suggests that the inefficient transport of photo-generated carriers occurs in the PSC. Ions such as Pb2+, CH3NH(3+) and I-vacancies cause the screening effect of built-in field and the photo-generated carriers cannot be separated nor collected efficiently. As a result, J(SC) and V-OC show small values in J-V curves measured at a fast scan rate. However, the degradation in PV performance is temporary. The PV performance gradually reaches a steady state at different operating temperatures with scan rate going down to 0.0017 V/s. The P-MPP and V-OC increase with temperature decreasing. These results indicate that a long illumination time is necessary for PSC to reach a steady state. After long-time illumination under biased condition (i.e., J-V curves measured at slow scan rate), the built-in field is compensated for by the external bias and the ions piling in the interface regions have enough time to diffuse towards the opposite direction. Thus, the screening effect of built-in field is reduced and the PV performance of PSC reaches a steady state. According to the result of device simulation, the increasing V-OC at low temperature is attributed to the enhanced built-in potential difference and the reduced recombination rate of carriers. The temperature-dependent external quantum efficiency measurements of planar PSC before and after light illuminationis are performed to investigate the mechanism of carrier transport. It reveals that the separation and collection efficiencies of photo-generated carriers can be improved significantly after light illumination due to the fact that the screening effect of built-in field is reduced. These findings help understand the carrier transport mechanism in planar PSC.

Understanding the temperature sensitivity of the photovoltaic parameters of perovskite solar cells

Exploring the Way To Approach the Efficiency Limit of Perovskite Solar Cells by Drift-Diffusion Model

Understanding Temperature‐Dependent Charge Extraction and Trapping in Perovskite Solar Cells

Thermal Management of PV Based on Latent Energy Storage of Composite Phase Change Material: A System-Level Analysis with Pore-Scale Model

Temperature-Dependent Time Response Characteristic of Photovoltaic Performance in Planar Heterojunction Perovskite Solar Cell

Thermal Modeling of Perovskite Solar Cells: Electron and Hole Transfer Layers Effects

Unveiling the Low‐Temperature Pseudodegradation of Photovoltaic Performance in Planar Perovskite Solar Cell by Optoelectronic Observation

Temperature‐Insensitive Efficient Inorganic Perovskite Photovoltaics by Bulk Heterojunctions

Heterojunction Perovskite Solar Cells: Opto-Electro-Thermal Physics, Modeling, and Experiment

New Insights into the Origin of Hysteresis Behavior in Perovskite Solar Cells

Transient performance modelling of ultra-thin Sn-based perovskite solar cells based on electrode contact design to improve thermal stability

Real-Time Dynamic Observation of a Thermal and Electrical Coeffect on the Interfacial Evolution of Hybrid Perovskite Solar Cells by Electrochemical Impedance Spectroscopy

Dependence of Power Conversion Properties of Perovskite Solar Cells on Operating Temperature

Thermal Management Enables More Efficient and Stable Perovskite Solar Cells

Achieving Small Temperature Coefficients in Carbon‐Based Perovskite Solar Cells by Enhancing Electron Extraction

The Effect of Energy Level of Transport Layer on the Performance of Ambient Air Prepared Perovskite Solar Cell: A SCAPS-1D Simulation Study

Exploring Optoelectronic‐Thermal Coupling in Perovskite Solar Cells Utilizing Varied Hole Transport Layers

Fundamental Understanding of Photocurrent Hysteresis in Perovskite Solar Cells

Evolved Photovoltaic Performance of MAPbI3 and FAPbI3-based Perovskite Solar Cells in Low-Temperatures

Efficient Perovskite Solar Cells over a Broad Temperature Window: the Role of the Charge Carrier Extraction

A Study of Hysteresis in Perovskite Solar Cell