Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Influence of scanning pattern on the edge collapse of solid parts in laser metal direct forming

Sidewall shape control using direct laser fabrication technology

Influence of Powder Flow on Sidewall Quality of Solid Parts in Laser Metal Direct Forming

Modeling and Reducing Edge Effects in Laser Bending

Edge Effects of Metal Plate in Laser Forming

Study on the Stability in Laser Cladding Forming Process of Thin-Wall Structures

Research on the Forming Process of Three-Dimensional Metal Parts Fabricated by Laser Direct Metal Forming

Effect of scanning tracks on the contour morphology and dimensional accuracy of the fine structure manufactured by laser powder bed fusion

Investigation of thermal and fluid dynamics behaviors of melt pool during laser direct metal deposition on inclined substrates

The Edge Effect Restraint Strategy of Plate under Laser Forming Technology

Investigation on the Formation Mechanism of Collapse Defects, Microstructural Evolution and Mechanical Properties in Full Penetration Laser Welding of Thick-Section Steel

Analysis and Control of Edge Effects in Laser Bending

Influence of Laser Different Waveform on Accuracy of Metal Direct Forming

Impact of Pulsed Laser Parameters and Scanning Pattern on the Properties of Thin-Walled Parts Manufactured Using Laser Metal Deposition

Self-Regulation-Effect in Laser Direct Metal Manufacturing

Thermal and dynamic characteristics in the corners of LPBF-fabricated TC4 multi-track parts and the impact of contour scanning

Controlling Edge Effects in Laser Bending

Effect of Scanning Routes on Forming Quality in Laser Rapid Forming

Influencing of Molten Pool Dynamic Behavior on the Weld Formation during the Laser‐Arc Hybrid Welding of 12 mm Thick Steel

Understanding Melt Pool Behavior of 316L Stainless Steel in Laser Powder Bed Fusion Additive Manufacturing

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet