Abstract:Fluid flow characteristics and particle motion behavior of an impinging stream reactor with dynamic inlet flow (both inlet velocity patterns exhibit step variation) are investigated and discussed with the computational fluid dynamics–discrete element method (CFD–DEM). The effect of T (variation period of the dynamic inlet flow) and ∆u (inlet velocity difference) on the motion characteristics of single and multiple particles, as well as the mean particle residence time, are studied and discussed. The research results indicate that, compared with the traditional impinging stream reactor (both inlet velocities are equal and constant) with equal mean inlet velocity (um) within one period, the impinging surface is instantaneously moving and the flow regime is varied with time in the impinging stream reactor with dynamic inlet flow. The impinging stream reactor with dynamic inlet flow provides higher cost performance over the traditional impinging stream reactor, under equal um, in terms of single-particle residence time. Moreover, three new particle motion modes exist in multi-particle motions of the impinging stream reactor with dynamic inlet flow; particles are accelerated by the original or reverse fluid and perform oscillatory motion at least once after an interparticle collision. Whether it is a single particle or multi-particles, the mean particle residence time reaches a maximum value when T/2 is approximately equal to the first particle acceleration time, since the maximum axial kinetic energy increases in every oscillatory motion compared with traditional impinging stream, and the number of oscillatory motions is increasing. The mean residence time of a particle in the impinging stream reactor with a dynamic inlet flow increases with increasing ∆u, since the dynamic inlet conditions and increasing ∆u can continuously supply more energy to particles and thus cause more particles to enter one of the three new modes of particle motion.

Experimental study of the law governing the movement of particles inside a gas-solid two-phase impingement flow

Effect of Agitation on the Fluidization Behavior of a Gas–solid Fluidized Bed with a Frame Impeller

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Research on motion characteristics of gas-solid jet flow

Numerical Simulations of a Gas–Solid Two-Phase Impinging Stream Reactor with Dynamic Inlet Flow

Movement of Impingement Heat Transfer by A Single Circular Jet with A Confined Wall

Flow characteristics in a semi-confined circular-pipe impinging jet

Numerical study of particle behavior in laminar axisymmetric opposed-jet flows

Penetration, accumulation, and swing characteristics of particle cloud in a turbulent axisymmetric opposed-jet flow

Study On Liquid-Like Behaviors Of Dense Granular Impinging Jets

Experimental Research on Fluidization Parameters of Air-Impingement Jet of Particulate Material

Experimental and Numerical Analyses of Gas–solid-Multiphase Jet in Cross-Flow

Experimental study on collision rates of inertial particles in particulate flows under the effect of gravity

Experimental Investigation of the Effects of Particle Near-Wall Motions on Turbulence Statistics in Particle-Laden Flows

Numerical Simulation of Gas-Particle Two-Phase Flow in Impinging Streams Gasifier

Numerical study on the motion of two parallel spherical particles with different diameters in upward flow

Distribution of Particle Resident Time in a Combined Coaxial Gas–solid Two-Phase Impinging Stream

Investigation on ultralight particle dispersions in dense two-phase flow using a kinetic friction stress model

Numerical studies of gas-solid flow behaviors and wall wear in a swirling fluidized bed