Abstract:The application of finite element models is a promising method for ensuring part quality during machining to accurately predict induced residual stresses and cutting forces. The present study applied Analysis System software to formulate a 3D model to predict induced residual stress and forces for AISI 1020 alloy. Taguchi method was applied in the design of the experiment with three levels and three factors selected: Cutting speed, feed rate and depth of cut. For validation, stresses are measured using an x‐ray diffractometer from the surface to a depth of 0.6 mm in steps of 0.2 mm. The cutting forces are determined using a force dynamometer. Simulation results showed that cutting speed, feed rate and depth of cut contributed 94.76 %, 0.048 %, and 0.11 % respectively. The predictive model equations were statistically significant with a p‐value of <0.005. The average induced residual stress on the superficial layer from the experiment and simulation were −367.7 MPa and −365.6 MPa respectively. The average residual stresses obtained at depths of 0.2 mm, 0.4 mm, and 0.6 mm were −260 MPa, −233 MPa, and −211 MPa, respectively. The proposed model offers a potential solution to reducing the costs of experimental methods. The paper aims to predict the induced residual stress and cutting forces during the turning of steel alloy using a finite element‐based model. This is achieved by modelling work material using Johnson‐Cook model during a simulation on analysis system software. Experiments are performed and results are compared for validation of the finite element model for predicting cutting parameters.

Simulation Research on AISI4340 Steel Ultra-Precision Cutting Process Based on FEM-SPH Coupling Method

Finite Element Simulation of High-Speed Cutting

Finite Element Simulation Of High-Speed Cutting Alloy Cast Iron

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Finite Element Simulation of Serrated Chip Formation in High-speed Milling of A lloy Cast Iron

Simulation of 3d Chip Shaping of Aluminum Alloy 7075 in Milling Processes

Simulation of Chip Formation in High-Speed Hard Machining

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

The Finite Element Analysis Of Serrated Chip Formation In High-Speed Cuffing Auto Panel Dies

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Finite Element Simulation and Analysis of Aluminum Alloy Three-Dimensional Milling

Finite Element Simulation and Analysis of Deformation in Machining of Aeronautical Aluminum Alloy Thin-Walled Workpiece

Key Technologies of Physics-Based Milling Process Simulation

Coupled Thermo-mechanical Model for Metal Orthogonal Cutting Process and Finite Element Simulation

Fe Analysis of the Effects of Cutting Speed on Thermomechanical Responses of Aisi 4142 Steel in High Speed Cutting

FEM mesh-dependence in cutting process simulations

Finite element simulation and regression modeling of machining attributes on turning AISI 304 stainless steel

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Finite element based model for predicting induced residual stresses and cutting forces in AISI 1020 steel alloy