Mechanical Properties and Uniaxial Failure Behavior of Concrete with Different Solid Waste Coarse Aggregates
Mei Zhou,Jinting Bai,Shaowei Li,Kai Zhang,Chao Li,Xinyi Wang
DOI: https://doi.org/10.3390/ma15186259
IF: 3.4
2022-09-09
Materials
Abstract:To reveal the differences between the mechanical properties of solid waste coarse aggregate concrete and natural coarse aggregate concrete (NCAC) under equal strength, the basic mechanical properties of coarse aggregate concrete with seven different solid wastes (i.e., self-combusted coal gangue, uncombusted coal gangue, marble sheet waste, granite sheet waste, iron waste rock, recycled concrete, and self-combusted coal gangue ceramicite) were tested, and the trends in failure morphology, elastic modulus, and the stress–strain full curves of the different solid waste coarse aggregate concretes were analyzed and compared with NCAC. Finally, the interfacial structure of the concrete was characterized by SEM. The results showed that C30 strength grade concrete was prepared with different solid waste coarse aggregates; however, the 28 d compressive strength, split tensile strength, axial compression strength, flexural strength, and elastic modulus of the concrete was 35.26–47.35, 2.13–3.35, 26.43–42.70, 2.83–3.94, and 17.3–31.2, respectively. The modulus of elasticity of the solid waste coarse aggregate concrete was smaller than the NCAC under equal strength, with a maximum difference of 45%. The peak compressive strain and ultimate compressive strain were larger than the NCAC, with a maximum difference of 43%. The crushing value of the solid waste coarse aggregate affected the splitting tensile strength, flexural strength, and modulus of elasticity of the concrete to a greater extent than the compressive strength. The transition zone at the concrete interface of the coarse aggregates with different solid wastes varied widely. The porous micro-pumping effect of the self-combusted gangue and self-combusted gangue vitrified reinforced the concrete interface transition zone, and the polished surface of sheet waste, uncombusted gangue, and recycled concrete aggregate surface adhesion weakened the interface transition zone; Finally, the uniaxial compressive stress–strain curve model for concrete with different solid waste coarse aggregates was established based on the Guo Zhenhai model.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering