Abstract:Biomass energy is the most abundant resource in the nature and it can be regenerated. Its sulphur content and ash content is lower, and its hydrogen content is higher than coal. It is one of the important energies which human depend on it to survive. Particle biomass fuel is a kind of solid fuel made by biomass material, with many advantages, such as high efficiency, clean molding, easy ignition, and low carbon dioxide emission, etc. It can replace other fossil fuels and can be used in the civil fields, such as cooking, heating, and other industrial fields, such as boiler burning and power generation. In this paper, the idea that particle biomass fuel is added into sintering production is presented. At the laboratory conditions, Φ 200 mm × 600 mm pot grate tests were carried out for three particle biomass fuel ratio (0%, 0.3%, 0.5%) respectively, vertical sintering speed were measured, they are 28.57 mm/min, 17.91 mm/min and 17.65 mm/min. Sinter metallurgical property were compared, reductive degree index are 65.72%, 81% and 83%, tumbler index are 70.13%, 51.03% and 50.87%, reduction degradation index (RDI + 6.3 mm) are 37.7%, 25.42% and 24.88%. The results show that it is difficult to use native biomass fuel in sintering process, Because it is easier to absorb more water, this leads to water content in the mix material higher than raw material, bed permeability is decreased, sintering speed is lower, the strength of sinter is decreased, but reduction degree index is higher. In the future biomass fuel carbonized will be further studied in sintering process.

Energy balance analysis of no.1 sinter machine at baosteel

Comparative Analysis for Thermal Utilization Efficiency of Baosteel Sinter Machines

Thermodynamic Performance Analysis of Associated Energy Combined Cycle System in Ironmaking Process

Exergoeconomic Analysis of A Combined Cycle System Utilizing Associated Gases from Steel Production Process Based on Structural Theory of Thermoeconomics

Comparative study on associated energy combined cycle system schemes in ironmaking process

Experiment research on utilization of particle biomass fuel in sintering process

EXPERIMENT STUDY ON THE EFFECT OF IRON ORE SINTER BEHAVIOR WITH ADDING BIOMASS

NOxremoval Coupled with Energy Recovery in Sintering Plant

Numerical study of gas–solid counterflow heat transfer in sinter vertical cooling furnace based on energy and exergy analysis

Intelligent Optimization and Impact Analysis of Energy Efficiency and Carbon Reduction in the High-Temperature Sintered Ore Production Process

Comprehensive Improving Technology for Air Leakage on Sintering System

Exergy efficiency analysis on large-scale circulating fluidized bed boilers

Numerical study and orthogonal analysis of optimal performance parameters for vertical cooling of sintered ore

Study on Influence of Air Distribution in Sintering Process on Sinter Quality

Practice of energy-saving and discharge-reduction with the 400 m~2 sintering machine at Handan Iron and Steel

Low Carbon and Deep-bed Sintering Practice of Laiwu Steel's 265m~2 Sinter Machine

Optimization of High-Alumina Blast Furnace Slag Based on Exergy Analysis

Optimization of Exergy Efficiency in a Walking Beam Reheating Furnace Based on Numerical Simulation and Entropy Generation Analysis

A Study of a Two-Phase Heat Transfer Mechanism in a Vertical Sintering Cooling Furnace

Numerical simulation and analysis of entropy generation and exergy equilibrium of the thermal process in a regenerative billet reheating furnace

Analysis and optimisation on the energy consumption of electric arc furnace steelmaking