Abstract:High energy, high repetition rates laser with excellent beam quality are fundamental components for LiDAR. In particular, high pulse energy is benefit for long distance range imaging. Narrow pulse width and high repetition rates are benefit for high resolution and high refresh rate operation of LiDAR. However, increasing the laser repetition rates will cause the pulse energy decreasing and the pulse width expanding. In order to achieve the requirements at the same time, we propose a 885 nm laser diode end-pumped RTP Q-switched Nd:YAG laser. Pulse pumping scheme was used to avoid heat accumulation. With a master oscillator power amplifier (MOPA) system, 40.5 mJ, 7.5 ns of 1064 nm pulses were obtained at 2 kHz. The beam quality factorM(2)was measured as 1.60/1.51. Moreover, by frequency doubling with a LBO crystal, 16.4 mJ, 6.5 ns of 532 nm laser with theM(2)factor of 1.52 and 1.50 was obtained. The 1064 and 532 nm pulses are suitable for avalanche photodiode arrays LiDAR and streak tube imaging LiDAR, respectively. The laser system is shown to accomplish high stability from temperature of -10 degrees C to 30 degrees C and vibration frequency of 10 to 100 Hz.

800 mJ high beam all-solid-state 1319 1319 nm pulsed laser

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

180 Mj, Long-Pulse-duration, Master-Oscillator Power Amplifier with Linewidth Less Than 256 Khz for Laser Guide Stars

High-Beam-Quality All-Solid-State 355 Nm Ultraviolet Pulsed Laser Based on A Master-Oscillator Power-Amplifier System Pumped at 888 Nm

180 mJ, long-pulse-duration, master-oscillator power amplifier with linewidth less than 25.6 kHz for laser guide stars.

885 Nm LD End-Pumped 22.7 W High Beam Quality Electro-Optical Q-switched Nd:YAG Laser

Diode Pumped All-Solid-state Pulsed 589 Nm Laser

589 nm laser generation by frequency doubling of a single-frequency Raman fiber amplifier in PPSLT.

High Efficiency High Beam Quality 1064 Nm and 532 Nm Dual-Wavelength Laser Switched by a Quartz Crystal

8.2 Kw High Beam Quality Quasi-Continuous-Wave Face-Pumped Nd:Yag Slab Amplifier

High Power Diode-Side-Pumped 1 112-Nm Nd:Yag Laser Based on Master-Oscillator Power-Amplifier System

High pulse repetition frequency all-solid-state 1053 nm Nd:YLF laser

95-Ps All-Solid-state Laser with a Low-Power Microchip Laser Seed and a Two-Stage Single-Pass Bounce Geometry Amplifier

High-energy Single Longitudinal Mode 1 Ns All-Solid-state 266 Nm Lasers

990 Nm High-Power High-Beam-Quality DFB Laser with Narrow Linewidth Controlled by Gain-Coupled Effect

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

Investigations of the High-Power, Single-Frequency, Sub-Microseconds, 1548-nm Fiber Laser Based on the Optical Pulse Modulation

High-Power High Beam Quality Narrow-Linewidth Quasicontinuous Wave Microsecond Pulse 1064-Nm Nd:YAG Amplifier

High Energylidarsource for Long Distance, High Resolution Range Imaging

A 1150-W 1018-Nm Fiber Laser Bidirectional Pumped by Wavelength-Stabilized Laser Diodes

Diode-Pumped 50 Hz–10 J Nano-Second Nd:YAG Laser