Abstract:Considering both supersonic and subsonic aerodynamic performances in aircraft design is challenging. This challenge can be alleviated through morphing design or plasma flow control. Therefore, if they are both considered in the aerodynamic optimization, the results can be undoubtedly improved. In this study, first, a new sliding shear variable sweep design scheme which can change both the plane shape (such as the span and sweep angle) and the wing profile (such as the chord length and the relative thickness) is proposed and some information about the elastomeric skin scheme is given. Second, an efficient global optimization framework based on surrogate-based optimization algorithm is established for the aerodynamic shape optimization of this morphing wing. Third, two optimizations are conducted, wherein one considers the effect of plasma actuation while the other does not. Due to the complexity and large calculations required, the effect of plasma actuation is not directly considered in computational fluid dynamics simulation but is indirectly considered by relaxing the subsonic lift constraint, which assumes that plasma actuation can offset the lift loss. Therefore, it is called "plasma constraint relaxation". In the two optimizations, three different configurations of the morphing wing which are 20°-, 30°- and 70°- sweep angle state, and three different flow conditions, which are subsonic (0.25 Ma), transonic (0.85 Ma) and supersonic (3 Ma) are considered. The results show that the comprehensive performance (objective function) improves by 12.6% with the effect of plasma actuation while it improves by 7.6% without the effect of plasma actuation after a two-round optimization. This suggests that the subsonic lift constraint, as an active constraint, significantly impacts the final optimization results. Finally, to verify whether plasma actuation can offset the lift loss, an experiment of nanosecond pulse dielectric barrier discharge plasma controlling flow separation is conducted to increase the subsonic lift of the optimization shape. The results show that the maximum lift increases by 18.1% when the actuation voltage is 8 kV and actuation frequency is 160 Hz and the lift loss caused by the constraint relaxation is 14.5%.

Structural Optimization of Actuator Distribution in the Sliding Wing

Adaptive Sliding Mode Control with Transition Process for Flapping Wing Aerial Vehicle

Structure Designation and Dynamic Model Analysis of Folding Wing for Underwater Vehicles

An Optimization on Single-crank-double-rocker Flapping Wing Mechanism

Experimental Structural Design of a Novel Variable-Sweep Wing Based on a Four-Bar Planar Linkage

A New X-Actuator Design for Controlling Wing Bending and Twisting Modes

A Novel Posture Alignment System for Aircraft Wing Assembly

Analysis And Design Of Active Morphing Units Based On Sma Actuators

Surrogate-based aerodynamic shape optimization of a sliding shear variable sweep wing over a wide Mach-number range with plasma constraint relaxation

Simulation and Optimal Design of a Piezoelectric Bimorph Actuator for Flapping-Wing Micro Aerial Vehicle

Wing Optimization of Propeller Aircraft Based on Actuator Disc Method

Wing Geometry and Kinematic Parameters Optimization of Flapping Wing Hovering Flight

Design and Rigid-Flexible Dynamic Analysis of a Morphing Wing Eight-Bar Mechanism

Comparison of structural parameterization methods for the multidisciplinary optimization of active morphing wing sections

Analysis and Optimization for a Chordwise Morphing Wing with Clearance Joints

Passive energy balancing design for a linear actuated morphing wingtip structure

Design optimization of a morphing winglet for all flight missions of a civil aircraft

Multidisciplinary optimization methodology for truss-braced wing aircraft using high-fidelity structure sizing

Surrogate-based aerodynamic shape optimization of a morphing wing considering a wide Mach-number range

SMA-actuated Morphing Wing with Varying Spanwise Curvature and SweptAngle.

Reduced-Order-Model-Based Placement Optimization Of Multiple Control Surfaces For Active Aeroelastic Control