Abstract:The variable-sweep wing, as an important morphing wing technology, has received widespread attention because it can change the sweep angle according to different flight conditions. It has the advantage of simultaneously utilizing a large sweep angle to reduce shock wave drag at high speeds and improving lift characteristics at small sweep angles. However, it has always been the case that the variable-sweep wing will bring about a rearward shift of the center of gravity when the sweep angle increases, leading to a decrease in aircraft stability. This paper focuses on a structural design of a variable-sweep wing based on a four-bar planar linkage. The novel variable-sweep wing structure containing a four-bar planar linkage and an outer wing section is proposed, and key parameters are extracted to establish a mathematical model of the mechanism. Through parametric analysis, main parameters have been identified, and the structure is optimized: the longitudinal position (direction of the fuselage) of the wing's center of gravity is designed to maintain minimal change during the morphing process, but remain the same at both the beginning and ending states of the transformation. The structural design of the variable-sweep wing is carried out based on this. Then, the finite-element model is established to validate the load-bearing capacity of the variable-sweep wing and derive the driving force. Finally, as one of the main novelties, a full-size prototype is successfully manufactured for load testing. The results of finite-element simulation and load testing show that this variable-sweep wing structure can achieve movement from 30 degrees to 70 degrees under an aerodynamic load that is up to 460 kg/m2. The present study demonstrates the effectiveness and potential of the proposed morphing trailing edge concept for real application on aircraft.

Experimental Structural Design of a Novel Variable-Sweep Wing Based on a Four-Bar Planar Linkage

Kinematics of a Morphing Wing with Variable Span and Sweep

Design of a variable-sweep wing structure with flexible shear skin

Design and Rigid-Flexible Dynamic Analysis of a Morphing Wing Eight-Bar Mechanism

Design, Analyze, and Simulation of a Bionic Swept-Back Wing Scheme with Force Amplification Mechanism

Mechanism Analysis of Hysteretic Aerodynamic Characteristics on Variable-Sweep Wings

Design and Validation of the Trailing Edge of a Variable Camber Wing Based on a Two-Dimensional Airfoil

Design and Analysis of a Variable-sweep Morphing Wing for UAV Based on a Parallelogram Mechanism

Design and analysis of a variable-sweep morphing aircraft with outboard wing section large-scale shearing

Effect of the Wing Morphology and Structural Form on the Flexible Hovering Flapping Wing

Design and Structural Analysis for a Camber-Morphing Wing with Deformable Truss

Modeling and Optimization Analysis of Hypersonic Variable Swept Wing Aircraft

System Design and Characteristics Analysis of a Variable-sweep and Variable-span Wing-body

Concept Design of Adaptive Wing with Flexible Trailing Edge

Proof-of-Concept Study of Flexible Lattice Variable Sweptback Wing

Design and experiment of concentrated flexibility-based variable camber morphing wing

Structure Design of Variable Camber Wing Trailing Edge Based on Multi-Block Rotating Mechanism

Design and Aerodynamic Characteristics of a Span Morphing Wing

Design and Experiment of Compliant Mechanisms-Based Morphing Wing

A New Architecture of Morphing Wing Based on Hyperelastic Materials and Metastructures with Tunable Stiffness

Design and Experiment of a Seamless Morphing Trailing Edge