Abstract:Microstructure characteristics are important for the high-performance Sm2Co17-type permanent magnets to achieve high intrinsic coercivity (H cj) and large magnetic field at the knee-point (H knee). In this work, the correlation between microstructures and magnetic properties has been systematically studied. The different microstructures were obtained by two procedures: by adjusting the aging temperature and optimizing the Zr content. On one hand, with increase of aging temperature from 1063 K to 1103 K, the cell size and the lamellar phase density increase from 75.1 nm and 0.014 1/nm to 101.5 nm and 0.043 1/nm, respectively, and the average peak Cu concentration at the cell boundaries reaches 21.9 at% which is helpful for obtaining relatively high H cj and H knee. As the aging temperature increases further to 1143 K, a much larger cell size and with incomplete cell boundaries results in an irregular distribution of Cu concentration at the cell boundaries. In this case, the H knee is low even though the magnet shows a high H cj. On the other hand, the increase of Zr content also promotes an increase in both the lamellar phase density and the average peak Cu concentration at the cell boundaries, giving rise to high H cj and H knee. Taking into consideration the aging temperature and Zr content, one can conclude that a lower aging temperature and lower Zr content produce a lower lamellar phase density and average Cu concentration at the cell boundaries and this leads to a lower H cj and H knee of the magnets. To further confirm this correlation between the microstructures and magnetic properties, a magnet of Sm(CobalCu0.062Fe0.285Zr0.016)7.6 was aged at a higher temperature of 1143 K to increase the lamellar phase density. As expected, the lamellar phase density increases from 0.008 to 0.013 1/nm; however, the cell size increases simultaneously from 142.5 to 247 nm. The magnet exhibits a much higher but uneven Cu concentration at the cell boundaries. As a result, the H cj increases from 1.64 to 10.18 kOe, while H knee just increases from 1.09 to 3.91 kOe.

Microstructure and intrinsic coercive force of Sm2Co17 type permanent magnet alloys by aging treatment

Aging treatment and magnetic properties for the 2: 17 type SmCo permanent magnets of high coercivity

Long Term Aging-Induced Microstructure and Magnetic Performance Changes in Sm-Co-Fe-Cu-Zr Magnets

Aging Treatment to Enhance Coercivity Through Grain Boundary Modification in SmFe10V2 Bulk Magnets

Growth of defects around grain boundary and evolution of cellular structure during isothermal aging process in 2:17-type SmCo permanent magnets

Aging Treatment and Kinetical Analysis of Sm_2Co_(17) Based Permanent Rare-Earth Magnets

Microstructure and magnetic properties of Sm2Co17-based high temperature permanent magnets

Dependence of macromagnetic properties on the microstructure in high-performance Sm2Co17-type permanent magnets

Enhanced Magnetic Properties of Fe-rich Sm-Co-Fe-Cu-Zr Magnets by Compressive Stress-Aging

Microstructural Characterization of Sm-Co Magnets

Effects of pre-aging on defects evolution and magnetic properties of Sm-Co-Fe-Cu-Zr magnet

Nanoscale short-range ordering induced cellular structure and microchemistry evolution in Sm2Co17-type magnets

Effects of Pre-Aging on Defects Evolution and Magnetic Properties of Sm-Co-Fe-Cu-Zr Magnets

Shortened Processing Duration of High-Performance Sm-Co-Fe-Cu-Zr Magnets by Stress-Aging

Microstructure and Coercivity Mechanism of Sm2Co17 Type High Temperature Rare-Earth Permanent Magnets

Effect of post-solutionizing cooling rate on microstructure and magnetic properties of 2:17-type Sm-Co-Fe-Cu-Zr magnets

Microstructure and its relationship with magnetic properties of high temperature 2∶17 type SmCo permanent magnets

Effect of interfacial stress on microchemistry and coercivity in 2:17-type SmCo sintered magnets

Influence of Exchange Coupling Interaction on Coercivity in 2:17-Type SmCo-based High Temperature Permanent Magnets

Study on Thermomagnetic Treatment Fe-25.5Cr-12Co Permanent Magnetic Alloy

Electron Microscopy and Magnetic Properties of Fe-Cr-Co-Si Permanent Magnet Alloys Manufactured by Rolling-Ageing Technique