Abstract:Microstructure characteristics are important for the high-performance Sm2Co17-type permanent magnets to achieve high intrinsic coercivity (H cj) and large magnetic field at the knee-point (H knee). In this work, the correlation between microstructures and magnetic properties has been systematically studied. The different microstructures were obtained by two procedures: by adjusting the aging temperature and optimizing the Zr content. On one hand, with increase of aging temperature from 1063 K to 1103 K, the cell size and the lamellar phase density increase from 75.1 nm and 0.014 1/nm to 101.5 nm and 0.043 1/nm, respectively, and the average peak Cu concentration at the cell boundaries reaches 21.9 at% which is helpful for obtaining relatively high H cj and H knee. As the aging temperature increases further to 1143 K, a much larger cell size and with incomplete cell boundaries results in an irregular distribution of Cu concentration at the cell boundaries. In this case, the H knee is low even though the magnet shows a high H cj. On the other hand, the increase of Zr content also promotes an increase in both the lamellar phase density and the average peak Cu concentration at the cell boundaries, giving rise to high H cj and H knee. Taking into consideration the aging temperature and Zr content, one can conclude that a lower aging temperature and lower Zr content produce a lower lamellar phase density and average Cu concentration at the cell boundaries and this leads to a lower H cj and H knee of the magnets. To further confirm this correlation between the microstructures and magnetic properties, a magnet of Sm(CobalCu0.062Fe0.285Zr0.016)7.6 was aged at a higher temperature of 1143 K to increase the lamellar phase density. As expected, the lamellar phase density increases from 0.008 to 0.013 1/nm; however, the cell size increases simultaneously from 142.5 to 247 nm. The magnet exhibits a much higher but uneven Cu concentration at the cell boundaries. As a result, the H cj increases from 1.64 to 10.18 kOe, while H knee just increases from 1.09 to 3.91 kOe.

Microstructure and magnetic properties of Sm2Co17-based high temperature permanent magnets

Atomic-scale structure clarification of the planar Z phase and its influence on the magnetic properties in Sm(CoFeCuZr) permanent magnets

Nanoscale short-range ordering induced cellular structure and microchemistry evolution in Sm2Co17-type magnets

Influence of 1:7 H phase stability on the evolution of cellular microstructure in Fe-rich Sm-Co-Fe-Cu-Zr magnets

Quantitative analysis of pinning-hardened intrinsic coercivity of Sm(CoFeCuZr)z (z = 7.0–7.8) high-temperature permanent magnets

Sm–Co high-temperature permanent magnet materials

Dependence of macromagnetic properties on the microstructure in high-performance Sm2Co17-type permanent magnets

Phase separation and chemistry evolution in Fe-rich Sm(CobalFe0.31Cu0.07Zr0.025)7.7 magnets: The effect of initial defect

Twinning, phase boundary structure and development of high coercivity in Fe-rich Sm2Co17-type magnets

Microstructure and magnetic properties of SmCo5 sintered magnets

Phase structure evolution and its effect on magnetic and mechanical properties of B-doped Sm 2 Co 17 -type magnets with high Fe content

Phase Separation and Chemistry Evolution in Fe-Rich Sm(Co Balfe 0.31cu 0.07zr 0.025) 7.7 Magnets: the Effect of Initial Defect

Microstructural Characterization of Sm-Co Magnets

2:17-type SmCo quasi-single-crystal high temperature magnets

Coercivity mechanism of high-performance anisotropic heterostructure SmCo 5 magnets

Correlation between ordered solid solution and cellular structure of Sm2Co17 type magnets with high iron content

Revisiting the Structural and Magnetic Properties of SmCo5/Sm2Co17 Interface from First-Principles Investigations

Identification of optimal solid solution temperature for Sm2Co17-type permanent magnets with different Fe contents

Overview of composition and technique process study on 2:17-type Sm–Co high-temperature permanent magnet

First principles study of transition-metal substitutions in Sm–Co permanent magnets

Microstructure and extrinsic magnetic properties of anisotropic Sm(Fe,Ti,V)12-based sintered magnets