Abstract:Partial Premixed Compression Ignition (PPCI) in diesel engine is a combustion mode between conventional diesel combustion and Homogeneous Charge Compression Ignition (HCCI) combustion, which has the potential to simultaneously reduce NOX and smoke emissions and also improve thermal efficiency. As a clean and renewable biofuel, n-butanol has many superior properties, such as good miscibility in diesel, low cetane number and high volatility, which make it an attractive alternative or blending component to diesel fuel to achieve PPCI. In this paper, PPCI combustion in a four-cylinder light-duty diesel engine fueled with n-butanol–diesel blends was achieved through early or late injection condition in which the whole amount of fuel was delivered before ignition. The aim of the project was to evaluate the potential in realizing Partial Premixed low temperature combustion with different fuel reactivity and oxygen content. The exploration strategies were focused on the early or late injection timing, injection pressure and load rate to evaluate the effects of n-butanol fuel characteristics on PPCI combustion and emissions. The effects of injection timing and load rate on PM mass-size distribution have also been investigated. Results show that both early and late injections have long premixed duration, which is helpful to form more homogeneous mixtures, making a great improvement on smoke emission. With the increase of n-butanol blending ratio, smoke emission can be reduced by up to 70%, while NOX shows a slight increase under moderate EGR rate. When the load rate is increased, the premixed combustion fraction decreases apparently, leading to a dramatic increase of soot mass due to the short ignition delay. It is meaningful to find that PPCI combustion can be achieved with reasonable injection timing, lower injection pressure, moderate EGR without penalties in fuel consumption when using high n-butanol blending ratios. Moreover, n-butanol-diesel blends can effectively reduce the soot mass when compared with pure diesel, but has little influence on the PM size distribution. Results indicate that n-butanol-diesel blends are more conducive to expand PPCI operating condition and improve engine performance and emissions.

Experiment on Combustion and Emission Characteristics of N-Butanol/biodiesel Dual Fuel HPCC

Experimental and Simulation Investigation of the Combustion Characteristics and Emissions Using N-Butanol/biodiesel Dual-Fuel Injection on a Diesel Engine

Emission, efficiency, and influence in a diesel n-butanol dual-injection engine

An Experimental Study on Combustion and Emissions of Gasoline/Diesel Dual Fuel HPCC

Investigation into partially premixed combustion fueled with N-butanol-diesel blends

Investigation of Butanol-Fuelled HCCI Combustion on a High Efficiency Diesel Engine

Effect of Premixed N-Butanol Ratio on the Initial Stage of Combustion in a Light-Duty Butanol/Diesel Dual-Fuel Engine

Experimental Study on Combustion and Emissions of N-Butanol/biodiesel under Both Blended Fuel Mode and Dual Fuel RCCI Mode

EFFECTS OF N-BUTANOL CONTENT ON THE DUAL-FUEL COMBUSTION MODE WITH CNG AT TWO ENGINE SPEEDS

Investigation on the Effects of Pilot Injection on Low Temperature Combustion in High-Speed Diesel Engine Fueled with N -Butanol–diesel Blends

Experimental investigation on the combustion and emissions characteristics of an N-butanol/CTL dual fuel engine

An Experimental on the Effects of Combustion Parameters on HPCC Combustion Fuelled with Gasoline/Diesel Dual Fuel

Ignition Mechanism of Highly Premixed Combustion for an Engine Fueled with n-Butanol/Biodiesel Dual Fuel

Investigation into Particle Emission Characteristics of Partially Premixed Combustion Fueled with High N-Butanol-diesel Ratio Blends

Partial Homogeneous Charge Compression Ignition Combustion of N-Heptane/biodiesel Dual Fuel Engine

Experimental Study Of The Effect Of Intake Oxygen Concentration On Engine Combustion Process And Hydrocarbon Emissions With N-Butanol-Diesel Blended Fuel

Effect of Combustion Boundary Conditions and n-Butanol on Surrogate Diesel Fuel HCCI Combustion and Emission Based on Two-Stroke Diesel Engine

The Potentials for Improving Combustion Performance and Emissions in Diesel Engines by Fueling N-Butanol/diesel/pode 3-4 Blends

Effects of Injection Timing and Pressure on Combustion and Emissions on an Engine Fueled with Diesel/Gasoline/n-Butanol Blends

Experimental Study of N-Butanol Additive and Multi-Injection on HD Diesel Engine Performance and Emissions

Experimental investigation on n-butanol/methyl oleate dual fuel RCCI combustion in a single cylinder engine at high-load condition