Abstract:<p>The yield strength of metals is typically governed by the average grain size through the Hall-Petch relation, and it usually follows the rule of mixture (ROM) for layered composite materials. In the present study, an extraordinarily high yield strength, far beyond the predicted values from the Hall-Petch relation and the ROM, is achieved in a specially designed layered titanium that is characterized by alternating coarse- and fine-grain layers (C/F-Ti) where the grain sizes match the layer thicknesses in both the coarse- and fine-grained layers. The strengthening mechanism of such a layered C/F-Ti is investigated based on detailed experimental characterizations, including nanoindentation tests of local hardness, in-situ synchrotron Laue X-ray microdiffraction (μXRD) measurement of the lattice strain distribution during tensile testing, and transmission electron microscopy (TEM) analysis of the dislocation structure after yielding. In the coarse-grain layers, significantly higher hardness values are observed next to the layer interfaces compared to the layer center regions, and <c+a> dislocations and densely populated pile-ups of <a> dislocations are exclusively observed in the interface regions after yielding. These experimental results point to an enhanced interface constraint effect on the deformation mechanism in hexagonal close-packed (hcp) materials with a large difference in the critical resolved shear stress between <a> slip and <c+a> slip. The C/F-Ti combines the strength of fine grains and the ductility of coarse grains, demonstrating a new structural design strategy for property optimization of single-phase hcp materials.</c+a></a></a></c+a></p>

Face-centered tetragonal titanium hydrides in fine-grained commercial pure (grade 2) titanium

Tensile and Low-Cycle Fatigue Behaviors of Commercially Pure Titanium Containing Γ Hydrides

Microstructure of Cyclically Deformed Titanium with Low Hydrogen Concentration I. Crystal Rotation and Formation of Cell Structure Near Hydrides

The Deformation Behaviors of Gamma Hydrides in Titanium under Cyclic Straining

An Investigation on Structure, Deformation and Fracture of Hydrides in Titanium with a Large Range of Hydrogen Contents

Microstructural Evolution and Formation Mechanism of FCC Titanium Hydride in Ti–6Al–4V–xH Alloys

The different deformation behaviors of the two types of gamma hydrides in pure titanium under cyclic straining

In-situ synchrotron-based high energy X-ray diffraction study of the deformation mechanism of δ-hydrides in a commercially pure titanium

In-situ synchrotron based high energy X-ray diffraction study of the deformation mechanism of δ-hydride in a commercially pure titanium

Dislocation Interaction with Hydrides in Titanium Containing A Low Hydrogen Concentration

Enhanced strength in pure Ti via design of alternating coarse- and fine-grain layers

High-cycle-fatigue Induced Continuous Grain Growth in Ultrafine-Grained Titanium

In situ TEM observation of HCP to FCC transitions in hexagonal close-packed titanium

Microstructural Modification and Mechanical Improvement of Ultrafine-Grained Ti Alloy Through Electron Wind Force: an Innovative Approach

Hydrogen Storage Properties and Crystal Structure of Ti-Cr Based Alloys

Interstitial carbon induced FCC-Ti exhibiting ultrahigh strength in a Ti37Nb28Mo28-C7 complex concentrated alloy

Formation of Titanium Hydride in Ti–6Al–4V Alloy

Characterizing solute hydrogen and hydrides in pure and alloyed titanium at the atomic scale

Microstructures and mechanical deformation behaviors of ultrafine-grained commercial pure (grade 3) Ti processed by two-step severe plastic deformation

The role of \b{eta} pockets resulting from Fe impurities in hydride formation in titanium

Microstructural evolution and FCC twinning behavior during hot deformation of high temperature titanium alloy Ti65