Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

High power supercontinuum source based on multi-core photonic crystal fiber

Experimental and Numerical Study of Supercontinuum Generation in Photonic Crystal Fiber

Supercontinuum generation based on nanofiber

Numerical investigation of a wideband supercontinuum source based on a large-mode-area photonic crystal fiber pumped at 1.3 μm

Supercontinuum Generation in Photonic Crystal Fiber and Tapered Single-Mode Fiber

Supercontinuum generation and control from large-mode-area photonic crystal fiber

High Power All-Fiber Supercontinuum System Based on Graded-Index Multimode Fibers

All-fiber high-power linearly polarized supercontinuum generation from polarization-maintaining photonic crystal fibers

Ultra-flat supercontinuum generated from high-power, picosecond telecommunication fiber laser source

Experimental Analysis of the Dependence Factor During Supercontinuum Generation in Photonic Crystal Fiber

[Study on the Supercontinuum Generation with Femtosecond Pulse in Photonic Crystal Fiber].

Design and analysis of the C 6 H 6 -filled circular photonic crystal fiber with ultra-flat dispersion for broadband supercontinuum generation with peak power of 130 W and 250 W

Numerical exploration of multi-octave spanned supercontinuum generation with high coherence in single material photonic crystal fiber

Power-efficient Coherent Supercontinuum Generation by Two-Color Pulses Pumping in a Highly Nonlinear Fiber.

All-fiber smooth supercontinuum generation in highly nonlinear dispersion-shifted fiber

More than 100 channels CW optical frequency chain generation from single supercontinuum source for DWDM systems

On-chip Two-Octave Supercontinuum Generation by Enhancing Self-Steepening of Optical Pulses

Ultra-broad Band Signal Amplification Using Supercontinuum Generation

Flat and broadband supercontinuum generation by four-wave mixing in a highly nonlinear tapered microstructured fiber.

10Ghz-Spaced over 1100 Channel Flat Supercontinuum Source Generated in a Microstructure Fiber

Near-infrared supercontinuum generation in an all-normal dispersion MOPA configuration above one hundred watts