Abstract:Micro-projector has found wide application in the field of mobile phone, pico-projector et al. However, because of the depth of the field of the projection lens, precise focus mechanical design is needed for the optical engineer to get fine and clear image.Wavefront coding technique is a novel technique which is introduced by Dowski and Cathey in 1995. By adding an aspheric phase mask at the pupil of the optical system, wavefront coding technique can make the imaging performance of the optical system insensitive to the defocus, and can also make the system insensitive to the defocus related aberrations, such as spherical aberration, chromatic aberration, field curvature, astigmatism and so on.In this paper, a projection lens with long depth of field for the CF-LCOS projector is developed to satisfy the new requirement. We first design the projection lens with the traditional optical design software to let it project the image to the average projection distance. For example, if the lens is designed with in the range of 0.65-2.0m, then about 1.0m is selected as the preliminary projection distance. After the lens (with a 3mm plane plate at the stop surface) is optimized with the CODE V in this distance, the plane plate is replaced with cubic phase plate. Then the lens is optimized again (the phase plate parameter varied for optimization) to get the final lens. In the new optimization, the resolution should be 3 times of the real resolution according to the LCOS resolution. This new optimized lens has the same MTF or PSF for different fields between 0.65 and 2m projection distances, this ensures the high resolution with no focus operation.Because of the MTF satisfies the LCOS requirement between the distance of 0.65 to 2m, no resolution is damaged and also no focus operation is need in this effective projection distance, thus no mechanical focus system is needed.

Compact Design of Projection Lens for 3D Profilometry Based on Interferometric Fringes

Compact Chromatic Confocal Lens with Large Measurement Range

Research on Two Optical Methods for Aspheric Measurement

3D Measurement System Based on Computer-Generated Gratings

Multi-Directional Lateral Shearing Interferometer Based on Rotatable Prism Pairs

Design of Off-Axis Reflective Projection Lens Using Spherical Fresnel Surface

The Design of Compact Structural Three Panels LCOS Projection System

A Projector Calibration Method for Fringe Projection System

Real-time Motion-Induced Error Reduction for Phase-Shifting Profilometry with Projection Points Tracking Method

Design of reflective projection lens with Zernike polynomials surfaces

Multi-Depth-of-Field 3-D Profilometry for a Microscopic System With Telecentric Lens

Full Area Covered 3D Profile Measurement of Special-Shaped Optics Based on a New Prototype Non-Contact Profiler.

A Practical Micro Fringe Projection Profilometry for 3-D Automated Optical Inspection

A novel projector ray-model for 3D measurement in fringe projection profilometry

Single-Shot Fringe Projection Profilometry Based on LC-SLM Modulation and Polarization Multiplexing

Autofocusing method for a digital fringe projection system with dual projectors

Super Wide Angle Projection Lens For Laser Display

Defocus Insensitive Projection Lens For Cf-Lcos Pico-Projector

High-frame Rate, Large-Depth-range Structured Light Projector Based on the Step-Designed LED Chips Array

Method to Design Two Aspheric Surfaces for a Wide Field of View Imaging System with Low Distortion

Autofocusing Method for High-Resolution Three-Dimensional Profilometry