Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Study of Electromagnetic Interference on Quench Detecting System of HTS Current Leads for EAST

Study of 16ka High Temperature Superconducting Current Leads Used in EAST's Toroidal Field Magnets System

Study on the Operation Safety of Hts Current Leads in East Device

Quench Detection of 20-kA HTS Current Leads Using Distributed Optical Fibers

Test Results About Simple CDA + MIK Quench Detection Method on EAST for ITER Superconducting CS Coils

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

A quench detection method for parallel co-wound HTS coils based on current redistribution

Quench Detection Utilizing Stray Capacitances

A new quench detection method for HTS magnets: stray-capacitance change monitoring

Research of quench detection for HTS coil with AC current

Investigation and Suppression of External Alternating Field of HTS Excitation Coil in Homopolar Inductor Machine

A Quench detection method for closed-loop superconducting coils based on currents redistribution in co-windings

Quench Detection Early Warning System Design on EAST

Thermal Behavior Modelling of a Fast AC Field Controlled HTS Switch

A Novel Approach to Quench Detection for High Temperature Superconducting Coils

Research on Quench Behavior of Second Generation HTS Coated Conductor under Two Hot Spots

Quench Judgement of HTS Coils in Power Systems under AC Current

Quench Protection Design of an 8-T Magnet Built With Low- and High-Temperature Superconducting Coils

Experimental Analysis of Quench Characteristic in HTS Tapes and Coils

R&D ON SHUNT FOR HIGH SAFETY HTS CURRENT LEADS FOR ITER

Sensitivity Analysis on a Quench Detection Method Based on Current Redistribution for Parallel Connected HTS Co-Windings